Patton electronic 2800 quick start Setting the IP address, Models with internal DC power supply

Page 3

1.3 Models with internal DC power supply

1.Strip insulation 1/4-inch from the wires connecting the power source to the IPLink.

2.Connect the ground terminal from the power source with to the E terminal on the IPLink.

3.Connect the negative (-) terminal from the power source with to the (-) terminal on the IPLink.

4.Connect the positive (+) terminal from the power source with to the (+) terminal on the IPLink.

The PWR LED blinks as the IPLink is powering up. When the PWR LED stops blinking and remains lit, the IPLink is ready for user configuration.

2.0Setting the IP address

2.1Default IP configuration

The factory default IP settings are as follows:

LAN port(s) (green, ETH 0/1): IP address: 192.168.1.1, netmask: 255.255.255.0

WAN port (red, ETH 0/0): IP address and netmask: DHCP client

A DHCP server with address space 192.168.1.10–192.168.1.99 (netmask: 255.255.255.0) is running on the LAN ports

Both Ethernet ports are pre-configured and active

If these addresses conflict or do not match with your network they must be changed. Contact your network administrator if you are not sure which IP address to use in your installation.

2.2 Connecting to the PC and logging in

1.To access the IPLink configuration, connect a PC with an Ethernet port to one of the LAN ports (green) (see figure 1). Use the black Ethernet cable included with your IPLink for this purpose.

PC

(DHCP, for example: 192.168.1.10/24)

IPLink 2800

192.168.1.1/24

Ethernet port

Connect to Ethernet LAN ports 0/1—0/4

Figure 1. Connecting to the PC’s ENET port

2.Set your PC’s TCP/IP configuration to DHCP to automatically receive an IP address from the IPLink.

IPLink 2800 Quick Start Guide

3

Image 3
Contents VPN Routers Powering up the IPLink Models with internal AC power supplyModels with external AC adaptors Connecting to the PC and logging Setting the IP addressModels with internal DC power supply Default IP configurationChanging the IP address Select the context IP mode to configure an IP interfaceConnecting the IPLink serial port Connecting to the networkAdditional information T1/E1 port default is disabled. Enable the T1/E1 portEC Declaration of Conformity Copyright statement
Related manuals
Manual 135 pages 34.01 Kb