Patton electronic 2800 quick start Copyright statement

Page 8

Copyright statement

Copyright © 2005–2006, Patton Electronics Company. All rights reserved.

The information in this document is subject to change without notice. Patton Electronics assumes no liability for errors that may appear in this document.

Trademarks statement

The term IPLink is a trademark of Patton Electronics Company. All other trademarks presented in this document are the property of their respective owners.

Patton support headquarters in the USA

Online support: Available at www.patton.com

E-mail support: E-mail sent to support@patton.com will be answered within 1 business day

Telephone support: Standard telephone support is available five days a week—from 8:00 am to 5:00 pm EST (1300 to 2200 UTC/GMT)—by calling +1 (301) 975-1007

Support via VoIP: Contact Patton free of charge by using a VoIP ISP phone to call sip:support@patton.com

Fax: +1 (253) 663-5693

Alternate Patton support for Europe, Middle East, and Africa (EMEA)

Telephone support: Standard telephone support is available five days a week—from 8:00 am to 5:00 pm CET (0900 to 1800 UTC/GMT)—by calling +41 (0)31 985 25 55

Fax: +41 (0)31 985 25 26

Note For additional service and support information, refer to the “Contacting Patton for assistance” chapter of the IPLink 2800 Series Getting Started Guide located on the CD-ROM that came with your IPLink Router or available online at www.patton.com.

Warranty, Compliance Information

For warranty, trademark and compliance information, refer to the IPLink 2800 Series Getting Started Guide located on the CD-ROM that came with your VPN Router or available online at www.patton.com.

Ultimate disposal of this equipment must be handled according to all applicable national laws and regulations.

CAUTION

8

IPLink 2800 Quick Start Guide

Image 8
Contents VPN Routers Models with external AC adaptors Powering up the IPLinkModels with internal AC power supply Setting the IP address Models with internal DC power supplyDefault IP configuration Connecting to the PC and loggingSelect the context IP mode to configure an IP interface Changing the IP addressConnecting to the network Connecting the IPLink serial portT1/E1 port default is disabled. Enable the T1/E1 port Additional informationEC Declaration of Conformity Copyright statement
Related manuals
Manual 135 pages 34.01 Kb