Model 3231 CLI Reference Guide6 • G.SHDSL Commands
gshdsl show
Display an atttribute for G.SHDSL.
| Table 53. gshdsl show | |
|
|
|
Command |
| Explanation |
|
|
|
gshdsl show |
| Display all attributes. |
|
|
|
gshdsl show <attrname> |
| Display a specific attribute. |
|
|
|
Example Output: gshdsl show
| |
General Information: |
|
Version : 1.00 |
|
Platform : Unknown |
|
Zip Wire Version : Software:4.2.0 | DSP Silicon:75.4 AFE:0.8 |
Connected : FALSE |
|
Modem State : In Progress |
|
Attributes Setting:
Action : Start
Clocking Combination : remote_receiverecover
Terminal : remote
DSLRate TS : 36
Serial TS : ACCESS FAILED
Data Rate I : 0
Actual Rate : 2304
Interface : atm
PCMMode : Ethernet
Loopback : Off
Clocking : Internal
TPClk Polarity : Normal
RPClk Polarity : Normal
Ghs Annex : AnnexA
Cnt Clear : Normal
Line Probe : Disable
IBit Mask : 0
LPOpt Rate : 0
TPSTCConfig : DoNotModify
Eth Link Kill : false
Status Information:
LBStatus : Off
Loss Of Signal : Signal Loss
Loss Of Sync Word : Sync Word Loss
Line Condition : Poor
Noise Margin : 0.0
Line Attenuation : 0
DSLSync State : Out Of Sync
Nb Dpll Lock : Not Locked
Dpll Lock : Not Locked
Rx Fifo Err : Normal
Tx Fifo Err : Normal
Tx Stuff Err : Normal
Valid TPClk : Valid TX PCM Clock
gshdsl show | 73 |