Patton electronic 2701/D, 2701/B, 2701/C user manual DC Power, There are no user-serviceable parts

Page 16

DC Power

The 36–60 VDC DC to DC adapter supplied with the DC version of the Model 2701 plugs in a DC source (nominal 48 VDC) and plugs into the barrel power supply jack on the rear of the 2701. Refer to Figure 5 to make the proper connection.

Figure 5. Connecting DC Power to the 2701 DC Power Supply.

 

There are no user-serviceable parts in the

 

power supply section of the Model 2701. Con-

 

tact Patton Electronics Technical support at

 

(301)975-1007, via our web site at http://

 

www.patton.com, or by e-mail at support@pat-

WARNING

ton.com, for more information.

 

 

16

Page 15 Page 17
Image 16
Page 15 Page 17
Contents User Manual Contents Page Radio and TV Interference Warranty InformationCE Notice Service Tel +1 301 Email support@patton.comGeneral Information FeaturesDescription Configuration DIP Switch ConfigurationSW1 SW2 SW3 SW4 SW5 Switch SW1-1 through SW1-5Speed SW1-6 SW1-7 Clock Mode SW1-6 and SW1-7 Clock ModesSW1-8 Enable/Disable Loop Tests from DTE S1-8 SettingPosition Function Factory Default Selected Option Switch SW2-1 Line Coding HDB3 defaultSwitch SW2-2 CRC-4 Multiframe Switch SW2-3 Data InversionSW2-2 Option SW2-3 OptionSwitch SW2-4 Remote Digital Loopback Type Switch SW2-5 Front Panel SwitchesSwitch SW2-6 V.54 Response Disabled default S2-4 RDL TypeInstallation Connecting to the G.703 NetworkConnecting the Twisted Pair 120 ohm to the G.703 Network Opening the CaseConnecting the Serial Port Connecting to a DTE DeviceConnecting to a DCE Device Power ConnectionUniversal AC Power 100-240 VAC Configuring the X.21 Interface 2701/DDC Power There are no user-serviceable partsPower supply section of the Model 2701. Con Tact Patton Electronics Technical support atPOWER-UP OperationLED Status Monitors TD & RDLoop V.54 & Telco Diagnostics Operating Local Loopback LLOperating Remote Digital Loopback RL Remote Loop in a Network Extension ApplicationUsing the V.52 BER Test Pattern Generator CSU LoopNetwork Connector Appendix aNetwork Data Rate Nominal ImpedancePower Supply TemperatureDimensions HumidityAppendix B Page Interface 34F Female Connector DCE Configuration Pin # Signal Appendix CPage Appendix D Appendix E Patton Model # Description
Top Page Image Contents