Patton electronic IM2RC/I-100B user manual Connecting the Line Interface, RJ-45 Line Interface

Page 15

5.4 CONNECTING THE LINE INTERFACE

The Model IM2RC/I-100B is to be used with Patton function card access products (i.e. 3088RC) There are two essential requirements for con- necting the line interface on Model IM2RC/I-100B:

1.These units work in pairs with one IM2RC/I-100B connected to another IM2RC/I-100B over 2 or 4-Wire Twisted pair (2 or 4-Wire operation is determined by the front function card).

2.To function properly, the Model IM2RC/I-100B needs one or two twisted pairs of metallic wire (two or four wire). The twisted pairs must be unconditioned, dry, metallic wire, between 19 (.9mm) and 26 AWG (.4mm) (Appendix B describes cable requirements). Stan- dard dial-up telephone circuits, or leased circuits that run through signal equalization equipment, or standard, flat modular telephone type cable, are not acceptable.

Figure 8. RJ-45 Line Interface

Note Two-wire modems use RJ-45 pins 4 and 5 and 4-wire modems use RJ-45 pins 3, 4, 5 and 6, as shown above. Refer to the Function Card User Manual for more details.

15

Image 15
Contents User Manual Specifications Warranty InformationConfiguration InstallationWarranty Information ServiceTel +1 301 Email support@patton.com Socket must have an earth ground Safety When Working with ElectricityPage Features General InformationDescription Typical Model IM2RC/I-100B application Typical ApplicationApplications PPP Operational BackgroundTransparent bridging between two routers over a serial link Unit a Unit B ConfigurationModel IM2RC/I-100B Driver Board mounted on Model 2701RC Connecting the Interface Driver BoardInstallation Model 1001R14 Rack Chassis Rack Power SupplyTion Front function card Mate into the rack chassisRJ-45 Line Side Connecting to the 10/100BASE-T Ethernet PortRJ-45 Line Interface Connecting the Line InterfaceLED Status Monitors POWER-UPOperation Operating InstructionsDimensions LED IndicatorsPower Consumption Temperature RangePage Page Copyright Patton Electronics Company All Rights Reserved