Patton electronic 4110 manual Ports descriptions

1 • General information Model 4520 & 4110 Series Getting Started Guide

Figure 3. SmartNode 4520 Series power input connectors

Ports descriptions

The SmartNode 4520 Series rear panel ports are described in table 3.

		Table 3. Rear panel ports
Port	Location	Description
10/100 Ethernet	Rear panel	RJ-45 connectors (see figure 2 on page 17) that connect the router to an Ether-
ETH 0/0 & ETH 0/1		net device (e.g., a cable or DSL modem, LAN hub or switch).
Voice Ports, FXS	Rear panel	FXS RJ-11/12 connectors (see figure 2 on page 17) that connect the router
		with an FXO port (a telephone for example). EuroPOTS support (ETSI
		EG201 188). Configured per model as follows:
		• SmartNode 4522—0/0, 0/1
		• SmartNode 4524—0/0, 0/1, 0/2, 0/3
		• SmartNode 4526—0/0, 0/1, 0/2, 0/3, 0/4, 0/5
		• SmartNode 4528—0/0, 0/1, 0/2, 0/3, 0/4, 0/5, 0/6, 0/7
Power	Rear panel	The gateway is available in a DC or AC power input version (see
		figure 3), labeled as follows:
		• AC version (Internal power supply): 100–240 VAC, 50/60 Hz
		• AC version (External power supply): 100–240 VAC, 50/60 Hz
		• DC version: 12 VDC
Console	Front panel	Used for service and maintenance, the Console port (see figure 4 on page 19),
		an RS-232 RJ-45 connector, connects the router to a serial terminal such as a PC
		or ASCII terminal (also called a dumb terminal).

18 SmartNode Series VoIP routers overview