Patton electronic 4110 manual Installing the Ethernet cable

Page 38

3 • Installation

Model 4520 & 4110 Series Getting Started Guide

 

 

Installing the Ethernet cable

The SmartNode 4520 Series has automatic MDX (auto-cross-over) detection and configuration on the Ether- net ports. Any of the two ports can be connected to a host or hub/switch with a straight-through wired cable (see figure 17). Ethernet devices (10Base-T or 100Base-T) are connected to the SmartNode’s Ethernet ports (see table 8 for port pin-out listing) via a cable terminated with RJ-45 plugs. A cross-over cable is only required when connecting SmartNode 4110 Series devices to a host (see figure 18 on page 39).

Table 8. Ethernet 10/100Base-T (RJ-45) port pin-outs

Pin

Signal

 

 

1

TX+

 

 

2

TX-

 

 

3

RX+

 

 

6

RX-

 

 

Note Pins not listed are not used.

Figure 17. Connecting to a hub

38

Installing the gateway router

Page 37 Page 39
Image 38
Page 37 Page 39
Contents SmartNode 4520 & 4110 Series Mailsupport@patton.com Contents Monitoring Status Cabling Contents Model 4520 & 4110 Series Getting Started Guide Radio and TV interference ServiceCompliance information CE notice EU declaration of conformityPage Structure About this guideAudience Precautions Safety when working with electricityPreventing electrostatic discharge damage General observationsTypographical conventions used in this document General conventionsMouse conventions DragPage Chapter contents General informationSmartNode Series VoIP routers overview SmartNode Router SmartNode 4524 shownSmartNode 4520 Series router Series rear panelsPorts descriptions LED descriptions SmartNode 4110 Series router SmartNode 4110 Series power input connectors SmartNode 4110 Series front panels General information SmartNode Series VoIP routers overview Applications Overview Terminal media gateway IntroductionApplications for SmartNode 4110 Series Application-Private line automatic ringdown Plar Application-Enterprise campus BRI to FXS telephony extensionApplication-PBX toll bypass gateway Toll bypassApplication-Desktop or LAN segment QoS Application-Point-to-point WAN QoS SwitchApplications for SmartNode 4520 Series Applications in combination with FXO models Application-SOHO off-premise extensionInstallation Planning the installation Create a network diagram see section Network information onInstallation checklist Task Verified by DateNetwork information Power sourceSite log IP related informationLocation and mounting requirements Installing the gateway routerConnecting cables Mounting the gateway routerAnalog FXS connection Pin Signal Installing the Ethernet cable Installation Installing the power cord Getting started with the SmartNode Steps for setting up a new SmartNode Connect with the serial interface Power connection and default configurationConfigure IP address Login Changing the IP addressConnect the SmartNode to the network Load configurationAdditional information Monitoring Status Status LEDs Monitoring Status LED Contacting Patton for assistance Warranty coverage Contact informationReturn for credit policy RMA numbersPage Appendix a Specifications Connectivity Voice processing signalling dependentVoice connectivity Fax and modem supportVoice Routing-Session Router Voice SignallingIP services Operating Environment DimensionsManagement SystemPower dissipation WeightPower supply AC versionPower supply Appendix B Cabling Connecting a serial terminal Serial consoleEthernet 10Base-T and 100Base-T Ethernet cross-overAnalog FXS Ethernet straight-throughAppendix C Port pin-outs FXS port Console portEthernet 10Base-T and 100Base-T port
Related manuals
Manual 78 pages 43.34 Kb
Top Page Image Contents