TP-Link TL-WN751ND manual FCC Statement

Page 3

FCC STATEMENT

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.

Increase the separation between the equipment and receiver.

Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

Consult the dealer or an experienced radio/ TV technician for help.

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:

1)This device may not cause harmful interference.

2)This device must accept any interference received, including interference that may cause

undesired operation.

Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

Note: The manufacturer is not responsible for any radio or TV interference caused by unauthorized modifications to this equipment. Such modifications could void the user’s authority to operate the equipment.

FCC RF Radiation Exposure Statement

This equipment complies with FCC RF radiation exposure limits set forth for an uncontrolled environment. This device and its antenna must not be co-located or operating in conjunction with any other antenna or transmitter.

“To comply with FCC RF exposure compliance requirements, this grant is applicable to only Mobile Configurations. The antennas used for this transmitter must be installed to provide a separation distance of at least 20 cm from all persons and must not be co-located or operating in conjunction with any other antenna or transmitter.”

Image 3
Contents TL-WN751ND Copyright & Trademarks FCC Statement CE Mark Warning Declaration of Conformity Contents Introduction Package ContentsFeatures Product OverviewStatus Working Status Hardware OverviewInstallation Hardware InstallationSoftware Installation TL-WN751ND TL-WN751ND TL-WN751ND TL-WN751ND To connect using Twcu Connect to a Wireless NetworkTL-WN751ND TL-WN751ND PBC Push Button Configuration method To connect using QSSAdapter will be connecting to the target network PIN method Enter a PIN into your AP device TL-WN751ND Windows To connect using Windows built-in wireless utilityWindows Vista TL-WN751ND Windows XP TL-WN751ND TL-WN751ND Management ProfileAdd a profile TL-WN751ND Delete a profile Modify a profileAdvanced About AP Mode TL-WN751ND Uninstall the utility software from your PC Uninstall SoftwareUninstall Driver Uninstall the driver software from your PCTL-WN751ND Normal Appendix a SpecificationsAppendix B Glossary TL-WN751ND