TP-Link TL-WA5210G manual FCC Statement

Page 3

FCC STATEMENT

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.

Increase the separation between the equipment and receiver.

Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

Consult the dealer or an experienced radio/ TV technician for help.

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:

1)This device may not cause harmful interference.

2)This device must accept any interference received, including interference that may cause undesired operation.

Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

Note: The manufacturer is not responsible for any radio or tv interference caused by unauthorized modifications to this equipment. Such modifications could void the user’s authority to operate the equipment.

FCC RF Radiation Exposure Statement

This equipment complies with FCC RF radiation exposure limits set forth for an uncontrolled environment. This device and its antenna must not be co-located or operating in conjunction with any other antenna or transmitter.

“To comply with FCC RF exposure compliance requirements, this grant is applicable to only Mobile Configurations. The antennas used for this transmitter must be installed to provide a separation distance of at least 20 cm from all persons and must not be co-located or operating in conjunction with any other antenna or transmitter.”

CE Mark Warning

This is a class B product. In a domestic environment, this product may cause radio interference, in which case the user may be required to take adequate measures.

Image 3
Contents TL-WA5210G 4GHz High Power Wireless Outdoor CPE Copyright & Trademarks FCC Statement Page Product Description 2.4GHz High Power Wireless Outdoor CPE EN623112008Yang Hongliang Product Manager of International Business Contents 10.1 III Package Contents Features Product OverviewOverview of the Product Conventions Indication Hardware InstallationLED Explanation Interfaces and buttonConnecting the Device System RequirementsEnvironment Requirements Page Configure the Device Quick Installation GuidePlease check the connection following these steps Quick SetupLogin Windows Quick Setup PPPoE IP parameters should have been provided by your ISP Click the Next button. You will then see the Finish AP Client Router & AP Router Operation Mode LoginStatus LAN WirelessTraffic Statistics Operation ModeNetwork WAN2 WAN 1 LANPage Page Page Page MAC Clone Wireless10 Wireless menu Basic SettingsWireless Mode 12 Wireless Mode Page Security Settings Page MAC Filtering Page Distance Setting Wireless StatisticsAntenna Alignment Throughput Monitor Dhcp21 The Dhcp menu Dhcp SettingsAddress Reservation Dhcp Clients ListWireless settings To modify a Reserved IP addressTo delete all Reserved IP addresses Click Clear All Forwarding 27 The Forwarding menu Virtual ServersPort Triggering Page 3 DMZ UPnP Security34 The Security menu FirewallIP Address Filtering Domain Filtering Page MAC Address Filtering Remote Management Advanced Security Page To add static routing entries Static Routing12 IP & MAC Binding Binding SettingARP List To add IP & MAC Binding entries, follow the steps belowTo find an existing entry, follow the steps below Dyndns.org Ddns Dynamic DNSOray.net Ddns Comexe.cn Ddns Snmp Community SettingTo modify a community setting entry Snmp System SettingTime System ToolsFirmware Select Using Daylight Saving Time59 Firmware Upgrade Factory DefaultsPing Watch Dog Backup & RestoreSpeed Test Reboot Syslog PasswordStatistics Table StatisticsIcmp BytesAP Operation Mode Quick Setup Operation Mode Wireless menu Page Wireless Mode Page Page Page Security Settings Page Page MAC Filtering Page Wireless Statistics Distance Setting Dhcp 18 The Dhcp menu Dhcp Clients List 22 Add or Modify an Address Reservation Entry To Reserve IP addressesWireless settings 24 Snmp Settings 26 Snmp System Setting 28 Firmware Upgrade Backup & Restore Speed Test Reboot Password Shown in Figure Figure A-2 PPPoE Connection Mode Appendix a FAQWant to use Netmeeting, what do I need to do? Figure A-3 MAC CloneWant to build a Web Server on the LAN, what should I do? Figure A-6 DMZWireless stations cannot connect to the router Configure TCP/IP component Appendix B Configuring the PC101 Figure B-3 ¾ Setting IP address manuallyNow Figure B-4Appendix C Specifications GeneralPhysical and Environment Appendix D Glossary

TL-WA5210G specifications

The TP-Link TL-WA5210G is a powerful outdoor wireless access point designed to provide extended coverage and high-speed wireless connectivity in challenging environments. Targeted at outdoor networking applications, this device is commonly utilized for establishing wireless connections across open areas, such as campuses, farms, and remote sites where traditional wired connections may not be feasible.

One of the standout features of the TL-WA5210G is its robust 12dBi directional antenna, which significantly enhances the range and signal strength. By focusing the wireless signal in a specific direction, users can enjoy stable connections over long distances, often exceeding 5 kilometers under optimal conditions. This long-range capability is complemented by support for IEEE 802.11g and IEEE 802.11b standards, providing a flexible and reliable wireless solution.

Equipped with a 5km wireless range, the TL-WA5210G operates on the 2.4GHz frequency band, enabling data transfer rates of up to 54Mbps. Users can also take advantage of a variety of modulation schemes, which optimize the device's performance in diverse environments. In addition, the access point supports WDS (Wireless Distribution System) functionality, allowing for the seamless expansion of wireless networks.

The device boasts an IP65-rated enclosure, making it highly resistant to dust and water, which is essential for outdoor installations. Furthermore, the TL-WA5210G operates in extreme temperatures, ranging from -30°C to 70°C, ensuring reliable performance in varying weather conditions.

For enhanced security, the TL-WA5210G incorporates multiple encryption protocols, including WEP, WPA, and WPA2, safeguarding users against potential threats. The user-friendly web interface facilitates easy installation and management, allowing users to configure settings quickly and efficiently.

In summary, the TP-Link TL-WA5210G is an ideal solution for anyone needing a reliable outdoor wireless access point. Its long-range capability, durable design, and comprehensive security features make it suitable for a wide range of applications, ensuring expansive and secure wireless coverage in outdoor settings. Whether for home, business, or community projects, the TL-WA5210G stands out as a versatile and efficient networking solution.