Component Description, CPU Cntl | Polycom RMX 2000 specification

Chapter 1- Hardware Description

Table 1-2Polycom RMX 2000 Component Description

Component	Description

CPU (CNTL)	The CPU Module controls and manages the RMX 2000.
Module	The CPU Module has an ComExpress Pentium-M 1.4
	GHz processor, a 40GB hard disk drive, 1GB Compact
	Flash and 512MB of DDR RAM.
	The Operating System is Linux.

Power Supply	The Power Supply Module is housed in a drawer and
Drawer	located below the MPM Modules. The Power Supply
	drawer is connected to the backplane by means of a
	power connector. Operates at 100-240 volts AC 50/60 Hz,
	and provides +48VDC 700W output with built-in load
	sharing capabilities.

Fan Drawer	Three fans are mounted sideways in the right front panel.
	Three fans are mounted in the drawer. Airflow is from right
	to left, and out the side of the MCU. The drawer is
	connected to the back plane by a connector.

Multi Processor	The MPM Boards, perform the various RTP, audio and
Module (MPM)	video processing functions on the RMX 2000 unit.
Board	Boards are based on the ATCA standard, with a card
	manager (CM) and up to 26 720Mhz TI DSP’s.
	Two types are available:
	•	MPM - F - 26 DSP’s
	•	MPM - H - 13 DSP’s

1-6

Component