Polycom® RSS™ 4000 Getting Started Guide – Version 6.0
For example, to set the IP address of LAN1 port to 172.21.103.29, subnet mask to 255.255.255.0 and gateway address to 172.21.103.254, enter the following command:
∙The same steps are also applicable for a Telnet connection.
∙Only one console (Telnet or RS232) at a time can be connected.
(Optional) Gatekeeper Configuration
If a gatekeeper is configured on your network, register the Polycom® RSS™ 4000 to the gatekeeper to simplify calling.
To register the system with the gatekeeper:
1Click System Config>Signaling Setting>Gatekeeper in the Web configuration interface.
2Set the following parameters in the gatekeeper page:
Parameter
Description
Register to Gatekeeper | Indicates whether or not to register the system with the gatekeeper. | |
You must check this option to set the following parameters. | ||
| ||
|
| |
Primary (Alternate) | Indicates whether or not the device is registered to the primary (or | |
Gatekeeper | alternate) gatekeeper. | |
|
| |
Gatekeeper IP Address | Specifies the IP address for the primary (or alternate) gatekeeper. | |
|
| |
Gatekeeper Port | Specifies the port number for the primary (or alternate) gatekeeper. | |
|
| |
System Prefix/E164. | Sets the E.164 number for the system. | |
|
| |
System H.323 Alias | Sets the H.323 alias for the system. | |
|
|
3Click Update and a dialog box will pop up, in which you should confirm to restart the system to apply the setting.
6