TP-Link AV500 Physical Interface, Hardware Connection, Description, Connecting to the Internet

TL-WPA4220/TL-WPA281300Mbps AV500/AV200 WiFi Powerline Extender

2.3 Physical Interface

There are four physical items on this device.

Wi-Fi/Wi-Fi Clone Button

			Ethernet Port
			Pair Button
			Reset Button
Item		Description
Wi-Fi/Wi-Fi	Press the button for 2 seconds to start Wi-Fi Clone.
Clone Button	Press the button for 5 seconds to enable or disable the wireless function.
Ethernet Port	Two 10/100Mbps Ethernet port connected to PC LAN card or broadband device.
Reset Button	Press the button more than 5 seconds, the device will restore to its factory
	defaults.
Pair Button	Pair buttons are used to secure a powerline network.

)Note:

1.If you press the Pair button for more than 10 seconds, the extender will leave the network it is associated with and its network name assumes a random value.

2.For detailed information about the Reset button and Pair button, please refer to Chapter 5 Pair Buttons.

2.4 Hardware Connection

Please first make sure that your PC can successfully access the Internet via the router. Then connect the powerline devices by following the instructions below.

Step 1: Connecting to the Internet

This section describes how to connect the powerline extender into your existing network. Follow the procedures described below:

1．Connect one end of an Ethernet (RJ45) cable to the Ethernet port of the powerline extender or a compatible powerline adapter like TL-PA4010.

5