Gigabit Smart Switch
CCCCCCCCCCConnection
4444 Ethernet Port
Connect a Ethernet port of the Switch to the computer by RJ45 cable as the following figure shown.
RJ45 Port
RJ45 Cable
FFFFFFFFFFF Connecting the RJ45 Port
4444 SFP Port
Connect the SFP port to a SFP module. If an SFP transceiver (purchased separately\ is installed in a slot and has a valid link on the port, the associated RJ45 port will be disabled and cannot be used.
SFP Port
SFP Module
FFFFFFFFFFFFInserting the SFP Module
Note: When using the SFP port with a 100Mbps module or a gigabit module, you need log on to the GUI (Graphical User Interface\ of the Switch and configure its corresponding Speed and Duplex mode on Switching→Port→Port Config page. For 100Mbps module, please select 100MFD while select 1000MFD for gigabit module. By default, the Speed and Duplex mode of SFP port is 1000MFD.
Connection 
15