TP-Link TD-W8901G manual FCC Statement

Page 3

FCC STATEMENT

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to pro-vide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not in-stalled and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.

Increase the separation between the equipment and receiver.

Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

Consult the dealer or an experienced radio/ TV technician for help.

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:

1)This device may not cause harmful interference.

2)This device must accept any interference received, including interference that may cause undesired operation.

Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

FCC RF Radiation Exposure Statement

This equipment complies with FCC RF radiation exposure limits set forth for an uncontrolled environment. This device and its antenna must not be co-located or operating in conjunction with any other antenna or transmitter.

“To comply with FCC RF exposure compliance requirements, this grant is applicable to only Mobile Configurations. The antennas used for this transmitter must be installed to provide a separation distance of at least 20 cm from all persons and must not be co-located or operating in conjunction with any other antenna or transmitter.”

CE Mark Warning

This is a class B product. In a domestic environment, this product may cause radio interference, in which case the user may be required to take adequate measures.

Image 3
Contents TD-W8901G 54M Wireless ADSL2+ Modem Router Copyright & Trademarks FCC Statement 2400.0-2483.5 MHz Country Restriction Reason/remark National RestrictionsZhao Jianjun Director of International Business Product Description 54M Wireless ADSL2+ Modem RouterContents Appendix a Specification Package Contents TD-W8901G Main FeaturesWireless Product OverviewConventions TD-W8901G54M Wireless ADSL2+ Modem Router User GuideLED Explanation Name Status Indication Front PanelBack Panel Installation EnvironmentConnecting the Router TD-W8901G54M Wireless ADSL2+ Modem Router User Guide Configure PC Quick Installation GuideTD-W8901G54M Wireless ADSL2+ Modem Router User Guide Configure the IP address as -4shows. After that, click OK Login Is the TCP/IP configuration for your PC correct?Is the connection between your PC and the Router correct? TD-W8901G54M Wireless ADSL2+ Modem Router User Guide Connection Type. Then click Next 54M Wireless ADSL2+ Modem Router User Guide Device Info StatusSystem Log Statistics Receive Receive total Bytes Statistics TableQuick Start Interface SetupInternet Dynamic IP Address PPPoA/PPPoE Static IP AddressTD-W8901G54M Wireless ADSL2+ Modem Router User Guide 2 LAN Bridge Mode54M Wireless ADSL2+ Modem Router User Guide How to assign a static IP address to the client? Wireless 54M Wireless ADSL2+ Modem Router User Guide WEP-64Bits WPA-PSK WEP-128BitsWPA2-PSK Advanced Setup FirewallRouting 3 NAT Virtual Server 3.1 DMZOther operations for the entries as shown in Figure To add a virtual server entryTo add a mapping rule 4 QoS Vlan Assign Vlan Pvid for each Interface Define Vlan Group Adsl1 ACL Access ManagementIP Filter Filter54M Wireless ADSL2+ Modem Router User Guide To add an IP Address filtering entry TD-W8901G54M Wireless ADSL2+ Modem Router User Guide To add a MAC Address filtering entry MAC Filter54M Wireless ADSL2+ Modem Router User Guide 54M Wireless ADSL2+ Modem Router User Guide To add a URL filter entry UPnP SnmpCwmp DdnsAdministration MaintenanceNTP Server automatically Time ZoneFirmware PC’s ClockManually To back up the Router’s current settings System Restart To restore the Router’s settingsHelp Diagnostic54M Wireless ADSL2+ Modem Router User Guide Appendix a Specification
Related manuals
Manual 15 pages 33.95 Kb