Installing The Remote Unit

NTI XTENDEX Wall Mount Extenders

The Remote Unit can either set on a desk near the monitor and speakers to be connected, or it can be mounted to a vertical surface using the wall mount brackets provided.

Attach Wall Mount Brackets

The two wall mount brackets can be secured to the Remote Unit using the four #4-40 x 1/4" screws provided (see Fig. 4). With the brackets attached, mount the Remote Unit to any desired surface using suitable hardware (not included). Be sure to position the Remote Unit such that the CAT5 cable, the monitor cable, and the speakers cable can each reach the Remote Unit without putting strain on the cables.

4-40X1/4" Flat Head Screw

Wall Mount Bracket

ST-C5VA-WL500

Remote Unit

(Bottom View)

Figure 4- Attach wall mount brackets to Remote Unit

Connect Monitor and Speakers

1.Position the Remote Unit such that the CAT5 cable, the monitor cable, and the stereo audio cable can each reach the Remote Unit without putting strain on the cables.

2.Connect the monitor cable to the female 15HD video connector on the Remote Unit.

3.Connect the cable from the remote speakers to the 3.5mm stereo audio jack on the Remote Unit (see Fig. 5).

Rear View of Remote Unit	15HD Female
Rear View of Remote Unit	Video Connector
XTENDEX
Inc Technologies Network

RNTI

VGA

Multi-Scan

Monitor

3.5mm Stereo

Audio Jack

Stereo

Speakers

Network Technologies ST-C5VA-WL500 Installing The Remote Unit, Attach Wall Mount Brackets