F1 | - Display firmware first digit (Note: F1 is )followed by NOT O) |
F2 | - Display firmware second digit |
F3 | - Display firmware third digit |
F5 | - Restore PS/2 mouse function |
F6 | - Restore IntelliMouse function |
F8 | - RESET all configurations to default settings. (Display confirms with ’r’). |
P - Sets password - see section 4.6 for instructions.
E - Exits configure mode and returns the LINDY CPU Switch Smart to normal operation mode.
2.8Resetting the LINDY CPU Switch Smart without disconnecting your devices
The LINDY CPU Switch Smart draws its power from the connected computers and therefore may only be fully powered down when all the connected computers have been switched off or disconnected. However, the LINDY CPU Switch Smart may be reset without disconnecting or powering down your computers by using the reset switch on the underside of the unit. Performing a reset using this switch performs a complete hardware reset on the LINDY CPU Switch Smart and is equivalent to switching off the power. To perform a hardware reset, move option switch 8 to the ON position (halt and reset) and then back to the OFF position (normal operation).
2.9 Other useful installation information
PC boot up sequence - When your PCs are powered on they communicate with any attached keyboards and mice and setup parameters required by the particular operating system. It is necessary for the LINDY CPU Switch Smart to be attached and powered on during this sequence so that it can give the required responses and keep track of all the modes and settings requested by each of the connected PCs.
Mouse characteristics - do not unplug a PS/2 mouse connection from a PC whilst the PC is on. Due to the design of PS/2 mice communications the mouse function on the PC will be lost and you will have to
LINDY CPU Switch Smart | Installation and Use | Page 16 |