Peavey CS 1000X manual Important Safety Instructions, II2

IMPORTANT SAFETY INSTRUCTIONS

WARNING: When using electric products. basic cautions should always be followed, including the following.

I.Read all safety and operatin g instructions before using this product.

7All safety and operating instructions should be rctaincd for future rcfcrcncc.

&.

3.Obey all cautions in the operating instructions and on the back of the unit

4.All operating instructions should be t’ollowcd.

5 This product should not be used near water, i.e., a bathtub, sink, swimming pool. wet basement, etc

6.This product should be located so that its position does not interfere with its proper ventilation. It should not bc placed flat against a wall or placed in a built-in enclosure that will impede the flow of cooling air.

I.This product should not be placed near a source of heat such as a stove. radiator, or another heat producing amplifier.

8.Connect only to a power supply of the type marked on the unit adjacent to the power s~~pply cord.

9.Never break off the ground pin on the power supply cord. For more information on groundin,,~7 write for our free hooklct “Shock HaLard and Grounding.”

IO. Power supply cords should always be handled carefully. Never walk or place equipment on power s~~pply cot&. Pet-iodically check cords for cuts or signs of stress. c~pecially at the plug and the point where the cord exits the unit.

I I, The power supply cord should be unplu pged when the unit is to he unused for long periods of time.

12.If this product is to be mounted in an equipment rack, rear support should be provided.

13.Metal parts can be cleaned with a damp rag. The vinyl covering used on some units can be cleaned with a damp rag or an ammoni;~- based household cleaner if necessary. Disconnect unit from power supply before cleaning.

14.Care should be taken so that objects do not fall and liquids are not spilled into the unit through the ventilation holes or any other openings.

IS. This unit should be checked by a qualified service technician if:

a.The power supply cord or plug has been damaged.

b.Anything has fallen or been spilled into the unit.

c.The unit does not opcratc correctly.

d.The unit has been dropped or the enclosure damaged.

16.The user should not attempt to service this equipment. All service work should be done by a qualified scrvicc technician

17.This product should be used only with a cart or stand that is recommended by Peavey Electronics.

IX. Exposure to extremely high noise lcvcls may cause a permanent hearing loss. Individuals vary considerably in \ujceptibility to noijc induced hearing loss, but nearly everyone will lose some hearing if exposed to sufficiently intense noise for a sufficient time.

The U.S. Government’s Occupational Safety and Health Administration (OSHA) has specified the following pcrmi\sihlc noi\c Icvcl exposures.

Duration Per Day In Hours	Sound Lebel dBA, Slow Response
x	90
6	Y2
3	YS
3	Yl
2	100
I II2	102
I	I OS
l/2	I IO
I /4 or less	11s

According to OSHA, any exposure in excess of the above permissible limits could result in some hearing 10~5.

Ear plugs or protectors in the ear canals or over the cars mu$t be worn when operating this amplification \y{tcm in ordcl- to prcvcnl a permanent hearing loss it’exposure is in cxccss of the limits as set forth above. To ensure against potentially dangcrouj cxposurc to high sound preajure levels, it is recommended that all persons exposed to equipment capable of producing high sound PI-C~WI-c levels such aj this amplification system be protected by hearing protectors while this unit is in operation.

SAVE THESE INSTRUCTIONS!

Features and specifications subject to change without notice.

Peavey Electronics Corporation 711 A Street / Meridian, MS 39301 / U.S.A. / (601) 483-5365 /Telex 504115 / Fax 486-1278

0 1 9 9 4 #80301955 Printed in U.S.A. 1 l/94