IOGear G-CS12, G-CS14 manual Installation

Page 8

Installation

Before you begin, make sure that the computers you’re going to connect to the MiniViewTM are turned off.

1Plug the monitor, keyboard, and mouse into the console port connectors of the MiniViewTM unit.

2Use the extender cables (as described in the Hardware Requirements and Unpacking sections) to connect the monitor, keyboard and mouse ports of the PCs to the MiniViewTM CPU ports, as shown in the diagram to the right. If your PC uses an AT style connector for the keyboard port, connect a PS/2-AT adapter to the end of the cable that will connect to the PC. If you don’t have a PS/2-AT adapter available, please contact us and we’ll be happy to provide one at no extra charge.

3Turn on the power to the connected PCs.

Image 8

Contents Page 1999 ATEN Technology, Inc. All Rights Reserved IBM is a registered trademark of International Business Machines, IncATEN is a registered trademark of ATEN Technology, Inc IOGEAR is a registered trademark of ATEN Technology, IncPacking List Packing ListContents ContentsFeatures ……………………………… Installation …………………..…………Introduction IntroductionFeatures FeaturesHot pluggable - add or remove connected PCs without powering Uses standard connectors to connect PC’sHardware Requirements Hardware RequireConsole CablesInstallation InstallationInstallation Installation Manual Port Selection OperationOperation Hot Key Port Selection Auto Scan Mode Last/Next ModeSelecting the Active Port 2-Port MiniViewTMAuto Scan Mode 3 Press EnterNext/Last Mode Appendix A Appendix ASpecifications LED DisplayAppendix B Appendix BTroubleshooting ProblemAppendix C Appendix CContacting IOGEAR info@iogear.comDAppendix Appendix DLimited Warranty Radio & TV Interference StatementIOGEAR 16560 Aston Street Irvine, CA Phone 949 Toll Free 888 Fax 949 info@iogear.com