IOGear GKM541R user manual Install the wireless combo on a brand new computer system

Hardware Installation

3.Install the wireless combo on a brand new computer system

-Before you turn on the system, make sure the batteries are installed for both keyboard and mouse and mouse batteries have been charged for at least two hours;

-Plug the USB charging station/receiver into an available USB port on your computer

-Power ON your computer

-Upon boot-up, your Operating System should detect the IOGEAR wireless keyboard/mouse combo and install any drivers, if necessary.

-Press the connect button on the USB Receiver

-Press the connect button located on the bottom of the mouse for a few seconds

-Move the mouse and make sure it is working properly

-Press the connect button on the USB Receiver

-Press the connect button located on the bottom of the keyboard for a few seconds

-Your IOGEAR Wireless Keyboard/Mouse Combo should now work wirelessly. If not, repeat the steps above again.

16