KTI Networks DH-8T manual

Page 11

When the number of 10Base-T nodes in your network exceeds eight, you need to connect at least two hubs to integrate all 10Base-T nodes into one network. You may connect one hub to another hub by using an ordinary UTP cable as the following steps:

1.Connect one end of the UTP cable to the jack labeled '8C' of Hub A.

2.Connect the other end of the cable to any available MDI-X jack of Hub B.

The maximum length of the UTP cable connecting two hubs is 100 meters.

Image 11

Contents 10Base-T Ethernet Hub United States Trademarks 10BASE-T Ethernet HUB Installation Guide Table of Contents Introduction Introduction IntroductionFeatures Checking AC Power InstallationInstallation Making Network Connections Network ConnectorsHub to Hub Connection via UTP Cable Connecting to an Ethernet NodePage Page Interpretations Locations of the Hub LED IndicatorsInterpreting Hub LEDs Collision LED RJ-45 Jack Pin Assignments SpecificationsAppendix UTP Cabling Specifications