KTI Networks DH-8T manual Trademarks

Page 3

The information contained in this document is subject to change without prior no- tice.

Copyright Ó KTI. All Rights Reserved.

TRADEMARKS

Ethernet is a registered trademark of Xerox Corp. NetWare is a registered trademark of Novell Inc.

WARNING:

This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and if not installed and used in accordance with the instruction manual may cause harmful interference in which case the user will be required to correct the interference at his own expense.

NOTICE:

(1)The changes or modifications not expressively approved by the party responsible for compliance could void the user’s authority to operate the equipment.

(2)Shielded interface cables and AC power cord, if any, must be used in order to comply with the emission limits.

CISPR A COMPLIANCE:

This device complies with EMC directive of the European Community and meets or exceeds the following technical standard.

EN 55022 - Limits and Methods of Measurement of Radio Interference Characteris- tics of Information Technology Equipment. This device complies with CISPR Class A.

WARNING: This is a Class A product. In a domestic environment this product may cause radio interference in which case the user may be required to take adequate measures.

CE NOTICE

Marking by the symbol CE indicates compliance of this equipment to the EMC directive of the European Community. Such marking is indicative that this equip- ment meets or exceeds the following technical standards:

EN 55022: Limits and Methods of Measurement of Radio Interference characteris- tics of Information Technology Equipment.

EN 50082/1:Generic Immunity Standard -Part 1: Domestic Commercial and Light Indus- try.

EN 60555-2: Disturbances in supply systems caused by household appliances and similar

electrical equipment - Part 2: Harmonics.

Image 3
Contents 10Base-T Ethernet Hub United States Trademarks 10BASE-T Ethernet HUB Installation Guide Table of Contents Introduction Introduction IntroductionFeatures Installation InstallationChecking AC Power Making Network Connections Network ConnectorsHub to Hub Connection via UTP Cable Connecting to an Ethernet NodePage Page Locations of the Hub LED Indicators Interpreting Hub LEDsInterpretations Collision LED Specifications AppendixRJ-45 Jack Pin Assignments UTP Cabling Specifications