SiI 3112 Controller.
4.7. Windows ME installation
1.Power off the system. Insert Combo Card into an available PCI slot. Power up the system.
2.During the system boot up, the Hardware Wizard will display that it found 'PCI standard
3.The Hardware wizard will display that it found 'PCI Universal Serial Bus'. Select
'Automatic search for a better driver (Recommended)', insert diskette driver into Floppy drives, and click 'Next', then click 'Finish' to exit the wizard.
4.The Hardware Wizard will display that it found a 'PCI Raid Controller', select 'Automatic search for a better driver (Recommended)'. Click 'Next'.
5.System will go through the enumeration process and install the driver. At the end of the process, click 'Finish' to complete the installation. Reboot the system if your Windows ME drive is connected on the SiI 3112 Controller.
4.8.Verifying The installation under Windows 98SE and ME
Follow the instructions in this section to verify that the controller was installed correctly.
1.Right click on 'My Computer' icon, select 'Properties', left click on 'Device Manager' tab.
2.Double click on 'System devices', then left click on 'PCI standard
3.Double click 'Universal Serial Bus Controllers', If there is no yellow '!' or '?' in front of
NEC PCI to USB Enhanced Host Controller
NEC USB Open Host controller
NEC USB Open Host controller
USB Root Hub
USB Root Hub
The driver has started correctly.
4.Double click on 'SCSI Controllers', If there is no yellow '!' or '?' in front of 'Silicon Image SiI 3112 SATARaid Controller', the driver has started correctly.
5.To view information about the devices attached to the controller, right click the
'Devices' and select Properties from the context menu, then select the tab labeled
- 10 -