Attaching the L-Brackets
Depending on your mounting scheme, use the L-brackets or the VESA 75mm standard holes located on the back of the kiosk monitor. See page 15 for VESA mounting information.
NOTE: You will need a screwdriver to attach the L-brackets.
Your kiosk touchmonitor comes with a mounting bracket (C-bracket) attached at the back. Included are two L-brackets (and four screws) that attach to both ends of the C-bracket for additional mounting options.
To attach the L-brackets:
1Lay the monitor face down.
2Place the long end of the L-bracket against the end of the mounting C-bracket. Line up the two holes of the L-bracket with the two holes of the C-bracket. See the illustration below.
C-bracket
L-bracket
3Place two screws in the holes and with the screwdriver, screw them in to secure the bracket.
4Repeat steps 2 and 3 to attach the other L-bracket to the other side of the mounting bracket.
2-6E l o E n t u i t i v e T o u c h m o n i t o r U s e r G u i d e
