Elo TouchSystems Comprehensive Guide to Installing the Elo Touch Driver for Windows 3.1 and MS-DOS

Page 25

Installing the Serial Touch Driver for MS-DOS and Windows 3.1

To install Windows 3.x and MS-DOS from Windows 95/98, follow the directions below:

1Insert the Elo CD-ROM in your computer’s CD-ROM drive.

2From DOS, type d:\EloDos_W31 to change to the correct directory on the CD-ROM (your CD-ROM drive may be mapped to a different drive letter).

3Type install and press Enter to start the installation.

4Align the touchscreen.

You must have already completed Steps 1 and 2 before proceeding. Refer to Chapter 2 of the Elo DOS and Windows Driver Guide as necessary for additional installation information.

To run the INSTALL program:

1Type INSTALL at the DOS prompt in the directory containing the driver install files.

2INSTALL asks you to select the software to install. Then choose d:\EloDos_W31 from the displayed list.

3INSTALL also asks you for the paths to use during installation, or you may use its defaults. INSTALL creates directories as necessary, and warns you if they exist.

If you are updating your software, you may wish to specify the paths containing the earlier versions, and overwrite the obsolete files. All executable programs are upward compatible. For a list of differences from each previous version of the drivers, be sure to select "Differences from Previous Versions" during the installation process.

INSTALL updates your AUTOEXEC.BAT file with the drivers you select. INSTALL makes a copy of your original AUTOEXEC.BAT file, called AUTOEXEC.OLD. If you already have Elo driver commands in your AUTOEXEC.BAT file, they will be commented out.

When INSTALL is finished, it leaves a file called GO.BAT in the subdirectory you specified. GO loads the touchscreen driver, runs the calibration program ELOCALIB, and gives you some final instructions.

If you are using Windows 3.1, you will also align the touchscreen within Windows 3.1 with the Touchscreen Control Panel.

2-20E l o E n t u i t i v e T o u c h m o n i t o r U s e r G u i d e

Image 25
Contents Elo Entuitive Touchmonitor User Guide Page Copyright 2005 Elo TouchSystems Inc. All Rights Reserved Page Table of Contents Introduction PrecautionsAbout the Product Page Unpacking Your Touchmonitor Installation and SetupProduct Overview Bottom View/Side View Attaching the L-Brackets Serial Connection Touch Interface ConnectionConnecting the Video Cable Connecting the Serial Touchscreen Cable Connect the Remote OSD Cable Connecting the Power Cable USB Connection Connecting the Video Cable Connecting the USB Touchscreen Cable Connecting the Remote OSD Cable Connecting the Power Cable Vesa Mount on Your Touchmonitor Optimizing the LCD DisplayInstalling the Driver Software Page Installing the Serial Touch Driver for MS-DOS and Windows Installing the USB Touch Driver for Windows 98 and Windows Installing the USB Touch DriverPage Using the On-Screen Display Menus About Touchmonitor AdjustmentsOperation Remote OSD Buttons Color Control OSD Menu FunctionPage Solutions to Common Problems TroubleshootingPage Input Video 15 LCD Native ResolutionPage Touchmonitor Safety Care and Handling of Your Touchmonitor Compatibility Modes Technical SpecificationsTouchmonitor Specifications ET1546L Force Surface Durability Expected Life Performance Sealing ET1546L LCD Touchmonitor DimensionsDetail a Scale 237 See Detail a ET1546L Rear Mount Plate Cut Out Cut Out DimensionsVertical Attachment Without Brackets Warranty Page Regulatory Information Electrical Safety InformationPage Page Page Index Vesa Mount on Your Touchmonitor