Assembly and Installation

CMA365

Installation Instructions

WARNING: Failure to provide adequate structural strength for this component can result in serious personal injury or damage to equipment! It is the installer’s responsibility to make sure the structure to which this component is attached can support five times the combined weight of all equipment. Reinforce the structure as required before installing the component.

1.Place two U-bolts (B) over supporting truss or pipe and insert through holes in truss plate (A). (See Figure 1)

NOTE: If mounting truss plate (A) to pipe, ensure that pipe fits into notches in plate. (See Figure 1)

2.Loosely install 3/8" nuts (E) and 3/8" washers (D).

NOTE: The washers (D) are only used for temporary installation of the CMA365. Washers MUST be removed before permanent installation.

3.Level mount and tighten nuts (E).

4.Install 1-1/2" NPT threaded column (purchased separately) into threaded collar until tight.

5.Install and securely tighten set screw (C) using the 5/32" hex wrench (F).

		(B) x 2
5	(C) x 1
		Supporting Pipe
		(A)
	2	(D) x 4	1	Pipe should fit
	2	(D) x 4	1	into notches
		3		(E) x 4

Figure 1