Chauvet f-95ww user manual Slaves

Operation

Reset

Performance Power

Output Options

Manual Zoom Control

Master/Slave Mode

To reset the OVATION™ F-95WW to the factory default settings, follow the instructions below.

1.Go to the SET main level.

2.Select the REST programming level and then the display becomes blank. Enter the passcode as described in Passcode. After successfully entering the passcode, REST blinks on the display during the reset process.

3.OK appears on the display when finished.

The OVATION™ F-95WW offers three power output options during the cooling of the fixture’s LEDs.

1.Go to the SET main level.

2.Select the PERF programming level.

3.Select from the following options:

∙Select LIVE to cool the LEDs by balancing the use of the fan and the power output level.

∙Select STDO to cool the LEDs by maintaining the use of the fan and limiting the power output level.

∙Select POWR to cool the LEDs by maintaining the use of the fan and allowing full power output.

The OVATION™ F-95WW has a 10° to 54° manually controlled zoom range. Adjust the zoom angle as follows.

∙Locate the zoom adjustment knobs on either side of the OVATION™ F-95WW and turn the knobs to increase or decrease the zoom angle.

The Master/Slave mode allows a single OVATION™ F-95WW (the “master”) to control the actions of one or more OVATION™ F-95WW units (the “slaves”) without the need of a DMX controller to control the slaves. The master will be set to operate in Master mode (MAST), while the slaves will be set to operate in Slave mode (SLAV). Once set and connected, the slaves will operate in unison with the master.

Configure the units as indicated below.

The Slaves:

1.Go to the RUN main level.

2.Select SLAV.

3.Connect the DMX input of the first slave to the DMX output of the master.

4.Connect the DMX input of the subsequent slaves to the DMX output of the previous slave.

5.Finish setting and connecting all the slaves.

The Master:

1.Go to the SET main level.

2.Select the MCON programming level.

3.Select MAST.

Note: If you select SELF, no DMX signals are sent to the slaves.

4.Make the master the first product in the DMX daisy chain.

5.Control the master using the DMX controller and the slaves will operate in unison.

Do not connect a DMX controller to the products configured for slave operation. The DMX controller may interfere with signals from the master.

OVATION™ F-95WW User Manual Rev. 2 -13-