LAMP
Using the Lamp menu, you can adjust the display settings of your projectors. The Picture menu, provides the following options:
LAMP HOUR—Displays the operating hours since the last lamp timer reset.
POWER SAVING—Select Yes to set the Power Saving delay period. The delay period is the time you want the projector to wait without an input signal. By default, the delay period is set to 120 minutes. However, you can set this to 5, 15, 30, 45, 60, or 120 minutes.
If an input signal is not detected during the delay period, the projector turns off the lamp and goes into power saving mode. If an input signal is detected when projector is in power saving mode, the projector automatically turns on. If an input signal is not detected within two hours, the projector switches from Power Saving mode to Power Off mode. To turn on the projector press the Power button.
ECO MODE—Select On to use the projector at a lower power level (216 Watts), which may provide longer lamp life, quieter operation, and dimmer luminance output on the screen. Select Off to operate at normal power level (256 Watts).
LAMP RESET—After you install a new lamp, select Yes to reset the lamp timer.
QUICK SHUTDOWN—Select Yes to turn off the projector with a single press of the Power button. This function allows the projector to quick power off with an accelerated fan speed.
NOTE: If Quick Shutdown is enabled, expect a slightly higher acoustic noise during power off.
