Getting Started Guide
>Make sure you have not installed multiple copies of the printer software:
a From the Start menu, click Settings 
Printers.
b In the Printers folder, make sure there is only one icon for your printer.
cIf you have two printer icons for the same printer, try printing a test page from each icon.
Uninstalling the software
If there is still a problem, uninstall and then reinstall the printer software:
1From the Start menu, click:
Programs 
Compaq A3000 
Uninstall Compaq A3000.
2 Follow the instructions on your screen.
3To reinstall the printer software, See “Install the printer software” on page 7.
Printer prints blank pages
Make sure you have removed the transparent tape covering the bottom of the print cartridges. For help, see page 4.
Paper misfeeds or multiple sheets feed
>Make sure you are using a paper recommended for inkjet printers.
>Do not force the paper down into the printer when you load it. Align the top of the paper with the top of the paper support.
>Do not load too much paper in the sheet feeder. The printer will hold up to 100 sheets of plain printer paper (and less sheets for heavier paper).
>Adjust the left paper guide so it rests against the left edge of the paper, but not so tight as to bow the paper in the feeder.
>Make sure the printer is on a flat, level surface.
Warm up
This is not an error. The scanner lamp is warming up after a period of inactivity and will take a few seconds to complete. Once the scanner lamp is warm, your job will be performed...no action is required.
28