Compaq 8030 manual Input Select Switch, Automatic Input Selection

Input Select Switch

The Video Channel Select control is located at the left-hand side of the lower front bezel. To the left and right of the Select control are two indicators that display the video channel that is selected. The left indicator is for Channel 1 and the right indicator is for Channel 2.

The TFT8030 has three video detection modes described in the following sections:

■Automatic Input Selection (Monitor Default)

■Input Recall

■User Input Selection using the On Screen Display

Automatic Input Selection

This section describes the monitor’s input detection scheme at the initial power-up or when the user has selected Auto Detect using the OSD for both Channels 1 and 2.

If only one active video input is connected, the monitor automatically enables and displays that input. If multiple video inputs are connected to the monitor (either active or in the energy saving sleep mode), the monitor detects and displays the factory default video summarized below.

Channel 1 is assigned to the first valid video connection in the following order:

■Analog 1

■Digital 1

Channel 2 is assigned to the first valid video connection in the following order:

■Analog 2

■Digital 2

■Super Video

■Composite Video

8 TFT8030 User’s Guide