QuickSpecs
HP Compaq 8100 Elite PC
Standard Features and Configurable Components (availability may vary by country)
Redundant Array of Independent Drives (RAID)
DriveLock is supported while in RAID mode. Users can manage the DriveLock password from within F10 Setup. Locked drives will be displayed as such in the RAID option ROM interface.
Hard drive information can be viewed within F10 Setup while in RAID mode. Previously, the hard drives will not appear in Drive Configuration when switching to RAID mode.
DPS Self Test can be executed on physical hard drives while in RAID mode.
The RAID Setup Utility (accessed through
NOTE: RAID 1 is the only RAID configuration offered via factory configurations. The
Are complete RAID systems and have both drives installed. If the CMT is configured with three hard disk drives, the third drive is would be unpartitioned and not part of the RAID array
Have the necessary Option ROM configuration.
Are
Include a preinstalled operating system that is mirrored mode out of the box.
Please refer to the HP White Paper titled "Advanced Host Controller Interface (AHCI) and Redundant Array of Independent Disks (RAID) on HP Compaq 8100 Elite Series PCs" at: http://www.hp.com for more information and instructions.
DDR3 Synchronous DRAM NON-ECC System Memory
Memory upgrades are accomplished by adding single or multiple DIMMs of the same or varied sizes. This chart does not represent all possible memory configurations. The HP Compaq 8100 Elite Series PC supports
CAUTION: You must shut down the computer and disconnect the power cord before adding or removing memory modules. Regardless of the
Supports up to 16 GB of DDR3 SDRAM using DIMM modules. Slot 1 is black and must always be populated. Not all memory configurations possible are represented below.
NOTE: For systems configured with more than 3 GB of memory and a
DA - 13524 Worldwide — Version 5 — February 3, 2010 | Page 8 |