SETTING
Power management
This function turns Projection Lamp off when this projector detects signal interruption and is not used for a certain period in order to reduce power consumption and maintain
Power Management function operates to turn Projection Lamp off when the input signal is interrupted and any button is not pressed over 5 minutes. This function operates as follows;
1.When any input signal is interrupted, “No signal” and the counting down display appears (for 5 minutes).
2.When Projection Lamp turned off, READY Indicator turns off. Cooling Fans operate and Projection Lamp is turned off for 90 seconds. (During this "Cooling Down" period, projector can not be turned on.)
3.When Projection Lamp has cooled down, READY Indicator flashes and Projection Lamp can be turned on again (Power Management mode).
In this Power Management mode, the Projection Lamp is automatically turned on when the input signal connected or projector is operated with any button on Top Control or on Remote Control Unit again.
On start
When this function is “On,” projector is automatically turned on just by connecting AC Power cord to a wall outlet.
Note ; Be sure to turn projector off properly (refer to the section “TURNING OFF THE PROJECTOR” on P19). If projector is turned off in the wrong steps, On Start function does not operate properly.
Remote control
This projector has two different remote control codes; the
When operating projector in “Code 2,” both projector and Remote Control Unit must be switched to “Code 2.”
To change the code of Projector;
Set Remote control in the SETTING MENU to “Code 2.”
To change the code of the Remote Control Unit;
Press both MENU and IMAGE buttons on Remote Control Unit together for over 10 seconds.
After changing the code, make sure Remote Control operates properly.
To return to the normal code (Code 1), repeat the above procedure.
NOTE : When batteries of Remote Control Unit are replaced or ALL- OFF switch is turned to
Lamp counter reset
This function is used to reset Lamp Replace Counter. When replacing Projection Lamp, reset Lamp Replace Counter by using this function. Refer to page 39 for operation.
Time left until Lamp off.
Press SELECT button at this icon to display other items.
Press SELECT button at this icon to display previous items.
Move the pointer to the item and then press POINT LEFT/RIGHT button(s).
Move the pointer to Lamp counter reset and then press SELECT button. The message “Lamp replace counter reset?” is displayed.
36