Christie Digital Systems 38-MX2001-01 user manual SETTING-UP Projector, Connecting AC Power Cord

Page 8

PREPARATION

SETTING-UP PROJECTOR

CONNECTING AC POWER CORD

This projector uses nominal input voltages of 100-120 V or 200-240 V AC. This projector automatically selects correct input voltage. It is designed to work with single- phase power systems having a grounded neutral conductor. To reduce risk of electrical shock, do not plug into any other type of power system.

Consult your authorized dealer or service station if you are not sure of type of power supply being in use. Connect a projector with a peripheral equipment before turning a projector on. (Refer to pages 12 ~ 15 for connection.)

Connect AC Power Cord (supplied) to a projector.

AC outlet must be near this equipment and must be easily accessible.

CAUTION

AC Power Cord must meet requirement of country where you use a projector.

Confirm AC plug type with chart below and proper AC power cord must be used.

If supplied AC Power Cord does not match AC outlet, contact your sales dealer.

Projector side

AC Outlet side

 

For U.S.A. and Canada

For Continental Europe

 

Ground

 

To POWER CORD

To AC Outlet.

 

CONNECTOR on a

To AC Outlet.

(120 V AC)

projector.

 

(200 - 240 V AC)

8

Image 8
Contents Model 38-MX2001-01 To the Owner Safety Instructions Voor de klanten in NederlandCompliances Federal Communication Commission NoticeTable of Contents Features and Design CompatibilityPreparation Name of Each Part of ProjectorFor U.S.A. and Canada For Continental Europe SETTING-UP ProjectorConnecting AC Power Cord Positioning Projector Preparation Lens InstallationLens Shift Adjustment Preparation Picture Level and Tilt Adjustment Moving ProjectorTerminals of Projector Connecting ProjectorReplacement of Terminal Connecting Projector INPUT/OUTPUT Terminals and Jacks Input Input 1Audio Output Jacks Connecting to Computer Terminals ProjectorConnecting to Video Equipment Cables used for connectionTOP Controls and Indicators Before OperationOperation of Remote Control Laser Pointer FunctionRemote Control Batteries Installation Flow of ON-SCREEN Menu Operation HOW to Operate ON-SCREEN MenuOperating ON-SCREEN Menu Before Operation Menu BAR Screen MenuBasic Operation Turning on / OFF ProjectorTurning on Projector Turning OFF ProjectorKeystone Adjustment Adjusting ScreenFocus Adjustment No Show Function Timer FunctionBasic Operation Picture Freeze Function Sound Adjustment Direct OperationMenu Operation Sound MenuComputer Input Selecting Input SourceSelecting Computer System InputComputer Input Automatic MULTI-SCAN System Select Computer System ManuallyAuto PC System MenuComputer Input Compatible Computer Specifications ResolutionPC Adjustment Auto PC AdjustmentPC Adjust Menu Computer InputComputer Input Manual PC Adjustment Full screen Display areaDisplay area H Picture Image Adjustment Image Level Select DirectImage Level Select Menu Image Select MenuComputer Input Image Level Adjustment Image Adjust MenuPicture Screen Adjustment Screen MenuVideo Input Selecting Video System Video InputAuto AV System Menu Video or S-VIDEOCinema Video Input Image Level Adjustment ColorTint Noise reductionProvides image at a normal video aspect ratio of 4 Setting Menu SettingSetting Menu To change code of Remote Control Unit To change code of ProjectorLamp counter reset Wireless Mouse modeProjector mode Operating Wireless Mouse MaintenanceInstallation Operating Wireless MouseAppendix AIR Filter Care and Cleaning Cleaning Projection LensAppendix Lamp Management Yellow Lamp Dim Lamp Red Lamp Mark on LampAppendix Lamp Replacement Figure shows case of replacing LampLamp Handling Precautions Troubleshooting Service Technical Specifications Appendix Configurations of Terminals DVI-I Terminal DIGITAL/ANALOGUSB Port Terminal Part No -A 610 307 2654 1AA6P1P4033-- ME7KW