31
Aspect Ratio | Use this function to choose your desired aspect ratio. | ||
| • | Auto: Keep the image with original | |
| • |
| mize the image to fit native horizontal or vertical pixels. |
| Full: Resize image to fit full screen by width (1280 pixels) and | ||
| • |
| height (800 pixels). |
| 4:3: The image will be scaled to fit the screen and displayed using | ||
| • | a 4:3 ratio. | |
| 16:9: The image will be scaled to fit the width of the screen and | ||
| • |
| the height adjusted to display the image using a 16:9 ratio. |
| L.Box: Keep original signal aspect ratio and zoom in by 1.333 | ||
|
|
| times. |
| <Note> "Full" and "L.Box" funcions are supported in P1300WB/ | ||
|
| P1303W. | |
|
| ||
Auto Keystone | Automatically adjusts vertical image. | ||
|
| ||
Manual Keystone | Adjust image distortion caused by tilting projection. (±40 degrees) | ||
| <Note> The Manual Keystone funcion is unavailable under Auto | ||
| Keystone setting to "On". | ||
|
|
|
|
H. Position | • | Press | to move the image left. |
(Horizontal | • | Press | to to move the image right. |
position) | |||
|
|
|
|
V. Position | • | Press | to move the image down. |
(Vertical position) | |||
| • | Press | to move the image up. |
Frequency | "Frequency" changes the projector's refresh rate to match the | ||
| frequency of your computer’s graphics card. If you can see a vertical | ||
| flickering bar in the projected image, use this function to make the | ||
| necessary adjustments. | ||
|
| ||
Tracking | Synchronizes the signal timing of the projector with the graphics card. | ||
| If you experience an unstable or flickering image, use this function to | ||
| correct it. |
| |
|
| ||
Sharpeness | Adjusts the sharpness of the image. | ||
| • | Press | to decrease the sharpness. |
| • | Press | to increase the sharpness. |
|
| ||
3D | Choose "On" to enable DLP 3D function. | ||
| • | On: Choose this item while using DLP 3D glasses, quad buffer | |
|
| (NVIDIA/ATI…) graphic card and HQFS format file or DVD with | |
|
| corresponding SW player. | |
| • | Off: Turn off 3D mode. | |
|
| ||
3D Sync L/R | If you see a discrete or overlapping image while wearing DLP 3D | ||
| glasses, you may need to execute "Invert" to get best match of left/ | ||
| right image sequence to get the correct image (for DLP 3D). | ||
|
|
|
|