SET UP YOUR LCD MONITOR
| Installation |
| Note: Please read last section “ Safety” before you install the LCD Monitor. |
| Notes |
| Please note the instruction below prior to installing your LCD monitor. |
| Installation Position |
| Choose a position where the reflection of light is minimal and away from a window for |
|
|
| maximizing the quality of the screen image. |
|
|
| It is important to keep 30 cm between the LCD monitor to minimize eyestrain. |
| Workstation Height |
| Position the LCD monitor slightly above your horizontal vision as you are sitting. |
| Angle of Vision |
| Tilt either forward or backward for the most comfortable viewing angle. |
| Quick Installation |
| This LCD monitor supports connection to a computer or workstation. The steps are |
|
|
| described as Quick Setup. |
|
|
| After installation, please refer to “Auto Adjust” for automatic adjust procedures. |
| Screen |
|
|
| Adjustments |
|
|
| Auto Adjust |
| Though your computer system can identify the new LCD monitor system, the Auto Adjust |
|
|
| function can be as to enhance the display. To enter adjust mode, please refer to “OSD |
|
|
| Control”. |
|
|
| Turn the computer and LCD monitor on. |
|
|
| Press ‘Auto’ button to start Auto Adjust. |
|
|
| The LCD monitor will start the Auto Adjust process automatically for 10 consecutive |
|
|
| seconds, where you will notice the image change as the Auto Adjust is working. |
| Self Test Function |
| Your LCD monitor provides a STFC function, through which you can check whether |
| Check (STFC): |
| the LCD monitor functions are working properly. |
|
|
| If your LCD monitor is properly connected, but there is no image showing and the |
|
|
| indicator light keeps orange, please follow the steps below to start STFC. |
|
|
| Shutdown computer and LCD monitor. |
|
|
| Unplug the signal connector from the back of computer. |
|
|
| Turn the LCD monitor on. |
|
|
| If the image connector is disconnected or damaged, the image shown on following |
|
|
| |
|
|
| figure will also appear during normal operation. |
Turn off the LCD monitor and reconnect signal cable, and then turn the computer and LCD monitor on.
If the LED of the LCD monitor is an orange color after completing the steps above, please check your VGA card and computer system. Your monitor should be operating properly.
English
4