Acer P206HLxbd manual Installation, EN-12

Page 13

INSTALLATION

To install the monitor to your host system, please follow the steps as given below:

Steps

1.1-1 Connect Video Cable

a.Make sure both the monitor and computer are powered-OFF.

b.Connect the VGA video cable to the computer.

1-2 Connect the Digital Cable (Only Dual-Input Model)

a. Make sure both the monitor and computer are powered-OFF. b. Connect one end of the 24-pin DVI cable to the back of the monitor and connect the other end to the computer’s port.

2.Connect the Audio Cable(Only Audio-Input Model)(Optional)

3.Connect power cord

Connect the power cord to the monitor, then to a properly grounded AC outlet.

4.Power-ON Monitor and Computer

Power-ON the monitor first, then power-ON the computer. This sequence is very important.

5.If the monitor still does not function properly, please refer to the troubleshooting section to diagnose the problem.

EN-12

Image 13

Contents Table of Contents EN-1 Special Notes on LCD MonitorsSafety instructions Information for your safety and comfortSafe listening EN-2LCD Pixel Statement Product servicingTips and information for comfortable use Finding your comfort zoneDeveloping good work habits Taking care of your visionEN-4 EN-5 UnpackingAttaching / Removing the Base Screen Position AdjustmentEN-6 Safety Precaution Connecting the Power CordCleaning Your Monitor EN-7DDC Power savingLight BluePin Color Display Signal Cable Connector PIN AssignmentGround Ground DDC-Serial ClockEN-10 EN-11 Standard Timing TableEN-12 InstallationEN-13 EN-14 Acer eColor Management Operation instructionsEN-15 Adjusting the OSD settingsEN-16 EN-17 EN-18 EN-19 TroubleshootingEN-20 DVI modeEN-21 Declaration of ConformityEN-22 Federal Communications Commission Declaration of Conformity