2.When the function is activated for the first time, a prompt will display on the screen. Use the 5 or 6 buttons to select a number for each digit of the password. Use the 3 or 4 buttons to move between the digits of the password..
3.When all digits are entered and the password is ready, press Auto to confirm. A confirmation message displays.
Password Setup
Enter Password | 0 | 0 | 0 | 0 |
Press
to Confirm Press 5 or 6 to change number Press 3 or 4to move
IMPORTANT: Write your selected password down here in this manual so that it is available to you should you ever forget it.
Password: __ __ __ __
Keep this manual in a safe place.
i.Press Auto to continue. The
completed” displays.
ii.Press 5 to go back to the previous screen and
iii.Press 6 to cancel the password
If you forget the password:
Password Setup
Do you want to use 0 0 0 0 as your password?
Yes | No 5 Cancel 6 |
You will be asked to enter the four digit password every time you turn on the projector. If you enter the wrong password, the password error message displays. You can retry by turning off the projector (by pressing Power) and start again, or if you did not record the password in this manual, and you absolutely do not remember it, you can use the password recall procedure.
To enter the password recall procedure:
Press and hold 4 for 5 seconds. The projector will display a coded number on the screen. Seek help from the local BenQ service center to decode the number. You may be required to provide proof of purchase documentation to verify that you are an authorized user of the projector.
To change the password:
1.Open the 
Setting > Change Password.
2.Press 3 or 4. A “Change Password” message displays.
3.Enter the old password.
i.If the password is correct, you can go on to enter new password.
IMPORTANT: Write your selected password down here in this manual so that it is available to you should you ever forget it.
Password: __ __ __ __
Keep this manual in a safe place.
ii.If the password is incorrect, a “Password Error” message displays. Press 5 to try again or press 6 to cancel.
4.Check the new password.
i.Pressing Auto completes the procedure.
ii.Press 5 to try again.
iii.Press 6 to cancel the
18 Operation