BenQ PB2250 user manual Warranty, Limited warranty

Page 43

Warranty

Limited warranty

BenQ warrants this product against any defects in material and workmanship, under normal usage and storage.

Proof of purchase date will be required with any warranty claim. In the event this prod- uct is found to be defective within the warranty period, BenQ’s only obligation and your exclusive remedy shall be replacement of any defective parts (labor included). To obtain warranty service, immediately notify the dealer from which you purchased the product of any defects.

Important: The above warranty shall be void if the customer fails to operate the prod- uct in accordance with BenQ’s written instructions, especially the ambient humidity must be in-between 10% and 90%, temperature in-between 0°C and 40°C, altitude lower than 10000 feet, and avoiding to operate the projector in a dusty environment. This war- ranty gives you specific legal rights, and you may have other rights which vary from country to country.

For other information, please refer to BenQ Warranty Information Book.

Warranty 39

Image 43

Contents Welcome Disclaimer CopyrightTable of Contents Iv Table of Contents Temperature informationSupported timing for Component-YPbPr Input But could fail if power cuts or surges Important safety instructionsImportant safety instructions Safety instructions Bedding or any other soft surface Locations near fire alarmsLocations with an ambient temperature Using the unit when it is not fullySafety instructions Introduction Projector featuresIntroduction Shipping contents Bottom side Projector exterior viewFront / Upper side Rear sideExternal control panel Controls and functionsFunctions Descriptions Remote control descriptionInstalling or replacing the remote control battery Remote control effective rangeChoosing a location Positioning your projectorFocus ring Zoom ring Obtaining a preferred projected image sizeScreen size chart 169 aspect ratio Screen size chart 43 aspect ratioConnection Connecting to a laptop or desktop computerConnection Video cable Audio cable Connection Connecting equipment to the Component Video inputConnecting Video and S-Video devices Video devicesVideo devices Video cable Start up Utilizing the password functionSwitch all of the connected equipment on OperationIf you forget the password Fine-tuning the image size and clarity Adjusting the imageAdjusting the height Auto-adjusting the imageCorrecting keystone On the remote controlHiding the image Switching input signalsShutdown Menu system Menu operationUsing the menus Picture menu Pro-Picture menu Setting menu Advance menu Lamp Hour ResolutionInformation Menu SourceCare of the projector MaintenanceReplacing the lamp Lamp informationMessage Status Do not turn the power on with the lamp cover removed Stand-by mode Temperature informationIndicators Light Status & Description Power Temp Lamp Power eventsThermal events Lamp eventsOptional accessories not included in the standard package Service informationAccessories included in the standard package Alternative accessories vary by regionsCause Remedy TroubleshootingPlug the power cord into the AC inlet on Make sure that it is switched onProjector specifications SpecificationsDimensions Supported timing for Video and S-Video inputs Timing chartSupported timing for PC input Supported timing for Component-YPbPrInputLimited warranty WarrantyWarranty MIC statement Regulation statementsFCC statement EEC statement