Onkyo HT-R518 instruction manual Adjusting the Listening Modes, Multichannel Subwoofer Setting

Page 56

HT-R518_En.book Page 56 Tuesday, March 11, 2008 11:31 AM

Adjusting the Listening Modes—Continued

Center Width

With this setting, you can adjust the width of the sound from the center speaker when using the Dolby Pro Logic

IIMusic listening mode. Normally, if you’re using a cen- ter speaker, the center channel sound is output by only the center speaker. (If you’re not using a center speaker, the center channel sound will be distributed to the front left and right speakers to create a phantom center). This setting controls the front left, right, and center mix, allowing you to adjust the weight of the center channel sound. It can be adjusted from 0 to 7. The default value is 3.

Multichannel Subwoofer Setting

SW InSens

On some DVD players, the signal from the multichannel subwoofer output is 15 dB higher than normal. You can change the subwoofer sensitivity to match your DVD player. Note that this setting only affects signals con- nected to the SUBWOOFER input jack of the multichan- nel DVD input.

You can select 0 dB (default), +5 dB, +10 dB, or +15 dB. If you find that your subwoofer is too loud, try the +10 dB or +15 dB setting.

Neo:6 Music

Center Image

The DTS Neo:6 Music listening mode creates 5-channel surround sound from 2-channel stereo sources. With this setting, you can specify by how much the front left and right channel output is attenuated in order to create the center channel. It can be adjusted from 0 to 5. The default value is 2.

When set to 0, the front left and right channel output is attenuated by half (–6 dB), giving the impression that the sound is located centrally. This setting works well when the listening position is considerably off center. When set to 5, the front left and right channels are not attenu- ated, maintaining the original stereo balance.

T–D (Theater-Dimensional) Setting

LstnAngl (Listening Angle)

With this setting, you can optimize the Theater-Dimen- sional listening mode by specifying the angle of the front left and right speakers relative to the listening position. Ideally, the front left and right speakers should be equi- distant from the listening position and at an angle close to one of the two available settings.

Front left speaker

Front right speaker

 

20˚/40˚

Narrow: Select if the listening angle is 20 degrees. Wide: Select if the listening angle is 40 degrees

(default).

56

Image 56
Contents HT-R518 Important Safety Instructions AvisPrecautions PowerSupplied Accessories PrecautionsMake sure you have the following accessories Speaker cable labelsContents Features AmplifierProcessing ConnectionsGetting to Know the AV Receiver Front PanelGetting to Know the AV Receiver DisplayRear Panel VCR/DVR IN/OUT DVD Front L/R, CENTER, SUBWOOFER, and Surr L/RRemote Controller Controlling the AV ReceiverUsing the Remote Controller Remote ControllerInstalling the Batteries Connecting Your Speakers Enjoying Home TheaterConnecting Your Speakers Connecting a Powered SubwooferUsing Dipole Speakers Speaker ConfigurationStrip about 5/8 Speaker Connection PrecautionsConnecting the Speaker Cables Connecting Antennas Connecting the Indoor FM AntennaConnecting the AM Loop Antenna Attach the FM antenna, as shownConnecting Antennas Connecting an Outdoor FM AntennaConnecting an Outdoor AM Antenna Using a TV/FM Antenna SplitterConnecting Your Components About AV ConnectionsOptical Digital Jacks AV Connection Color CodingConnecting Your Components Connecting Audio and Video Signals to the AV ReceiverWhich Connections Should I Use? Video Connection FormatsConnecting a TV or Projector Video ConnectionAudio Connection HintDVD player Connecting a DVD playerMultichannel analog audio output, see Hooking Up the Multichannel Input Connecting a VCR or DVR for Playback VCR or DVRMake the audio connection a Connecting a VCR or DVR for RecordingSignal flow CBL/SAT in S Connecting Components with Hdmi About HdmiAbout Copyright Protection HT-R518 Pass-thruAudio Signals Making Hdmi ConnectionsTurn on the AV receiver, and then assign the Hdmi in see TipConnecting a Camcorder, Game Console, or Other Device Make the video connection a Make the audio connection aCamcorder, game console, etc Camcorder or consoleStep An MC head amp and phono preamp are necessary toCD player CD or turntableConnecting a Cassette, CDR, MiniDisc, or DAT Recorder Coaxial CBL/SAT OpticalConnecting an RI Dock Not all iPod models output videoIf Your iPod Supports Video If Your iPod Doesn’t Support VideoConnecting Onkyo Components Connecting the Power CordSome components may not support all Functions ComponentsDo the automatic speaker setup-this is essential Turning On the AV ReceiverTurning On and Standby Up and Running in a Few Easy StepsFirst Time Setup Automatic Speaker Setup Audyssey 2EQUsing Audyssey 2EQ Measurement PositionsFirst Time Setup Error MessagesHdmi Input Setup To Retry the Automatic Speaker SetupChanging the Speaker Settings Manually Using a Powered SubwooferComponent Video Input Setup Digital Input SetupThis setting can only be changed on the AV receiver Changing the Input DisplaySelect a listening mode and enjoy See Using the Listening Modes onPlaying Your AV Components Basic AV Receiver OperationSetting the Display Brightness Using the Sleep TimerCommon Functions Muting the AV Receiver7Using Headphones Common FunctionsDisplaying Source Information Interpreting Surround Channel InformationSpecifying the Digital Signal Format Press and hold the AV receiver’sDigital Input button for about SecondsListening to AM/FM Stations Tuning into AM/FM Radio StationsListening to the Radio Tuning into Stations by Frequency Listening to the RadioDisplaying AM/FM Radio Information Actual display depends on countryDeleting Presets Presetting AM/FM StationsSelecting Presets Using RDS What is RDS?RDS Program Types PTY This allows you to search RDS radio stations by type seeFinding Stations by Type PTY Displaying Radio Text RTListening to Traffic News TP Using the Listening Modes Selecting with the Remote ControllerSelecting the Listening Modes Selecting on the AV ReceiverAnalog and PCM Sources Using the Listening ModesListening Modes Available for Each Source Format Dolby Digital Sources DTS Sources Use this mode with any stereo movie e.g., TV, DVD, VHS About the Listening ModesOnkyo Original DSP Modes Recording from Different AV Sources RecordingRecording the Input Source Adjusting the Listening Modes Using the Audio Adjust SettingsMultiplex/Mono Settings PLII/Neo6 SettingsTheater-Dimensional Setting Adjusting the Listening ModesMultichannel Subwoofer Setting Using the Audio Settings Tone Control SettingsAudyssey Dynamic EQ Music OptimizerUsing the Late Night Function Dolby Digital only Using the CinemaFILTERSpeaker Levels SyncFor the HT-S5105 Home Theater System Cos- tomer Advanced SetupSpeaker Setup Double Bass Advanced SetupCrossover Frequency Speaker Distance Turn up the volume so that you Can hear the test tone suffiCiently Repeat so that the levelEqualizer Settings Buttons to selectPress the Down button, Then use the Left and RightControlling Other Components Preprogrammed Remote Control CodesEntering Remote Control Codes Resetting the Remote Controller Remote Control Codes for Onkyo Components Connected viaResetting the Remote Mode Buttons Controlling Other ComponentsControlling a DVD Player, or DVD Recorder Controlling a VCR or PVR Controlling a Satellite Receiver or Cable Receiver Controlling a CD Player, CD Recorder, or MD Player Disc +/- buttonControlling an RI Dock Controlling a Cassette Recorder Controlling a TV ON/STANDBY, TV buttonsTroubleshooting Troubleshooting Remote controller doesn’t work Sound changes when I connect my head- phonesCan’t control other components Can’t recordSpecifications Amplifier SectionGeneral Video SectionMemo HT-R518En.book Page 78 Tuesday, March 11, 2008 1131 AM HT-R518En.book Page 79 Tuesday, March 11, 2008 1131 AM Onkyo Europe Electronics GmbH Onkyo Europe UK Office