Barco MGP D5 manual Using the Projector, Dvi-D

User Guide USING THE PROJECTOR

USING THE PROJECTOR

After setting-up, switch on all equipment.

To switch the projector on, firmly press the POWER button on the keypad or the remote control. The STATUS indicator will turn from yellow to green when the unit is switched on.

If the STATUS indicator is flashing yellow, please wait until it turns permanent yellow.

When only one source is connected, the projector will auto- detect that source. If more sources are connected, the projector will search for the next active source according to the following list, provided that SOURCE SCAN is set to ON in the SET UP sub menu (see description of menu system):

•VGA 1

•VGA 2

•DVI-D

•Component

•S-Video

•Composite Video

Select between the sources by pressing the SOURCE buttons on the keypad or the remote control. Only sources that are active will be displayed.

If no source is active, searching messages will appear on the screen.

If no source is active for a long time, the projector will go in standby mode if DPMS (power save) is set to ON in the SET UP sub menu. The STATUS indicator will turn from green to flashing yellow, then yellow. The projector will be switched back on if at least one source is (re)activated. The power-down function can be disabled in the menu. See DPMS in the SET UP sub menu.

To switch the projector off, firmly press the POWER button on the keypad or the remote control twice (to confirm that you really

MGP D5 23