APPENDIX
CLEANING THE LENS
Follow these steps to clean the projection lens:
1.Apply a
Abrasive cleaners, solvents or other harsh chemicals might scratch the lens.
2.Lightly wipe the cleaning cloth over the lens.
3.If you don't intend to use the projector immediately, replace the lens cover.
TROUBLESHOOTING
Before calling your dealer or service station for assistance, follow these steps, to make sure everything is properly connected.
1.Make sure you have connected the projector to your equipment as described in section "CONNECTING THE PROJECTOR" on pages 14 ~ 21.
2.Check cable connections. Verify that all computer, video and power cords are properly connected.
3.Verify that power is switched on.
4.If the projector still does not display an image, restart the computer.
5.If the image still does not display, unplug the projector from the computer and check the computer monitor's display. The problem may be with your graphics controller rather than with the projector. (When you reconnect the projector, remember to turn the computer and monitor off before you power up the projector. Power the equipment back up in this order: Projector, monitor, computer)
6.If the problem still exists, check the following chart.
Problem: | Try these Solutions: |
|
|
No power. | ● Plug the projector into an AC outlet. |
| ● Turn the MAIN ON/OFF button to ON. |
| ● Press the LAMP POWER ON/OFF switch to ON. |
| ● Be sure the READY INDICATOR light is ON. |
| ● Wait one minute after the projector is turned OFF before turning the projector |
| back on. |
| NOTE: After pressing the LAMP POWER ON/OFF button to OFF. The projector |
| functions as indicated. |
| 1. The LAMP POWER indicator will light and the READY indicator will turn off. |
| 2. After one minute, the READY indicator will light green again and the projector |
| may be turned on by pressing the LAMP POWER ON/OFF button. |
| ● Check temperature warning indicator. If the indicator flashes red, the projector |
| cannot be turned on. |
| (See "BASIC OPERATION" section on page 32). |
| ● Check the projection lamp. |
| ● Replace the lamp cover. (Check the interlock switch inside of the lapm cover.) |
|
|
Image is out of focus. | ● Adjust the focus. |
| ● Make sure the projection screen is at least 4.9' (1.5 m) from the projector. |
| ● Check the projection lens to see if it needs cleaning. |
| NOTE: Moving the projector from a cool temperature location to a warm |
| temperature location may result in moisture condensation on the lens. In |
| such an event, leave the projector OFF and wait until condensation |
| disappears. |
|
|
55