Proxima ASA DP9270 manual Computer Input Manual PC Adjustment

COMPUTER INPUT

MANUAL PC ADJUSTMENT

This projector can automatically tune to display signals from most personal computers currently distributed. However, some computers employ special signal formats which are different from standard ones and may not be tuned by Multi-Scan system of this projector. If this happens, projector cannot reproduce a proper image and image may be recognized as a flickering picture, a non-synchronized picture, a non-centered picture or a skewed picture.

This projector has a Manual PC Adjustment to enable you to precisely adjust several parameters to match with those special signal formats. This projector has 5 independent memory areas to memorize those parameters manually adjusted. This enables you to recall setting for a specific computer whenever you use it.

Note : This PC ADJUST Menu cannot be operated when in digital signal input on DVI terminal and “RGB” is selected on PC SYSTEM MENU (P23).

E

1	Press MENU button and ON-SCREEN MENU will appear. Press	PC ADJUST MENU
	POINT LEFT/RIGHT button to move a red frame pointer to PC

ADJUST Menu icon.

2	Press POINT DOWN button to move a red frame pointer to item
	that you want to adjust and then press SELECT button.

Adjustment dialog box will appear. Press POINT LEFT/RIGHT button to adjust value.

Fine sync

Adjusts an image as necessary to eliminate flicker from display. Press POINT LEFT/RIGHT button to adjust value.(From 0 to 31.)

Total dots

Number of total dots in one horizontal period. Press POINT LEFT/RIGHT button(s) and adjust number to match your PC image.

Horizontal

Adjusts horizontal picture position. Press POINT LEFT/RIGHT button(s) to adjust position.

Vertical

Adjusts vertical picture position. Press POINT LEFT/RIGHT button(s) to adjust position.

Current mode

Press SELECT button to show information of computer selected.

PC ADJUST Menu icon

Move a red frame icon to item and press SELECT button.

	Shows status
Selected Mode	(Stored / Free) of
	selected Mode.

Press POINT LEFT/RIGHT button to adjust value.

Press SELECT button at this icon to adjust “Clamp,” “Display area (H/V)” or set “Full screen.”

Clamp

Current mode

Adjusts clamp position. When image has a dark bar(s), try this adjustment.

Press SELECT button at Current mode icon to show information of computer connected.

24