Rackmount Solutions 600VA, 1200VA Power On Indicator, Backup indicator, Battery Fault Indicator

2.1 “Power On” Indicator

Power On indicator illuminates when utility power’s condition is normal.

2.2 “BACKUP” indicator

The indicator illuminates when the power is supplied from the batteries.

2.3 “Battery Fault” Indicator

This illuminates indicating weak battery. Recharge the battery for at least four hours. If after recharging this still illuminates, replace the battery by following the instructions in the manual.(You can plug out then check battery)

2.4 Power Switch

Can be used as the master on/off switch of your equipment by leaving your equipment connected to UPS and switched on.

2.5 UPS Outlets

Provide instantaneous back-up power protection to your equipment. Supply temporary uninterrupted operation for your equipment during power failure.

2.6 Bypass Power Sag Outlets

Provides bypass power sag protection to your equipment. Prevent power problems traveling through your system via unprotected peripherals.

2.7 Circuit Breaker Protection

Serves as an overload and fault protection. This is a critical component of the advanced UPS

2.8 “Phone Jack” Communications Ports

Telecom transfer ports provide users to extend the applications.

●Caution: To reduce the risk of fire, use only No. 26AWG or larger telecommunication line cord.

2.9 communication function

Provide RS-232 interface and UPSMON software to support NOVELL, UNIX, DOS, WINDOWS and other operating systems.

5