Remote Control Transmitter Identification, PinP∗

2.4 Remote Control Transmitter Identification

INPUT

Press the VIDEO or RGB button to select the input source. Press again to select the next source.

STANDBY/ON

Set main power switch to ON. Press STANDBY/ON button to begin projection mode (lamp on) or press and hold button for 1 second to switch to standby mode (lamp off).

VIDEO RGB

LASER

STANDBY/ON POSITION

LASER

Press and hold down button to project laser pointer.

CAUTION

To prevent injury to eyesight, do not point laser beam at other persons or look directly

into laser beam.

POSITION∗

Press button then use DISC PAD to move image (RGB signal only) up/down or left/ right.

ENGLISH

DISC PAD∗/ LEFT MOUSE BUTTON

For menu screens, press DISC PAD to select menu items. For non-menu screens, press DISC PAD for mouse shift or left mouse button function.

MENU∗

Press the remote control button to display the menu screen.

MAGNIFY∗

Press the MAGNIFY (+) to enlarge the center of the display image. Press again to enlarge image to maximum of 4X magnification. Press MAGNIFY (-) to reduce the display image size. Press OFF to return to normal image size. (Can be used with the POSITION button to select

RESET

FREEZE

MAGNIFY VOLUME

–OFF

PinPMUTE

BLANK AUTO TIMER

+ +

FOCUS ZOOM

– –

RESET∗/ RIGHT MOUSE BUTTON

For menu screens, press button to return to initial settings. For non-menu screens, press button for right mouse button function.

FREEZE∗

Press button to turn ON/OFF the freeze image function.

VOLUME∗

Press up to increase or down to decrease speaker volume.

MUTE∗

Press button to turn the mute function (speaker sound) ON/OFF.

TIMER∗

Press button to turn the menu screen timer ON/OFF. The timer does not display when the blank function is active.

the image area being magnified.)

PinP∗

Press the PinP button to display a video signal as a small picture-in-picture screen in the corner of an RGB display. Press it again to enlarge the picture-in-picture screen size. Press it a third time to exit the PinP screen and turn the function OFF. The position of the picture-in-picture screen can be controlled by pressing the POSITION button or from the Image menu. (Both RGB and Video signals must be present for the picture-in-picture screen to operate.)

BLANK ON

Press button to turn ON/OFF the screen blanking function.

FOCUS

Press (+) or (-) to adjust the image sharpness.

∗This button will not function if the message "NO INPUT IS DETECTED" or "SYNC IS OUT OF RANGE" is displayed.

ZOOM

Press (+) to increase or (-) to decrease the size of the displayed image.

AUTO∗

Press the AUTO button to activate the auto sync function. The message “AUTO IN PROGRESS” will display for several seconds as the projector adjusts the V. POSIT, H.POSIT. H.PHASE, & H. SIZE settings. The Auto Sync function will not operate under the following conditions:

•Initial screen message NO INPUT IS DETECTED or SYNC IS OUT OF RANGE is displayed.

•Freeze and Magnify functions have not been turned off prior to pressing AUTO button.

•Software application running on your computer is not set to maximum screen size prior to pressing AUTO button.

3M ™ Multimedia Projector MP8770