3M MP8760 manual Lamp Life Indicator, Cleaning the Projector

6-3. Lamp Life Indicator

The elapsed operating time of the lamp is displayed on the Info sub-menu. From the Main menu, select INFO to display the lamp life. As long as the lamp indicator bar is green, the lamp is good. When the bar changes to red, the lamp should be changed.

After changing the projection lamp, the lamp life indicator must be reset to zero.

To reset the lamp life indicator:

1.Press the Menu button to display the main menu.

2.Select the Advanced Setup sub-menu using the Disc Pad.

3.Select Reset lamp display and press the Enter button.

4.The following message will display: “Really reset lamp life display? OK! / Cancel”

5.Using the Disc Pad, select OK! and press Enter to acknowledge the change.

6.Press Menu to exit the menu system.

!Note

To view the used/remaining lamp life:

(1)Go to the Main Menu.

(2)Select “Info”.

(3)Press the Enter button.

6-4. Cleaning the Projector

For best performance, keep your projector free of excess dust and surface dirt. Use a soft cloth to remove dust from the projector housing. Use 3M High Performance Cleaning Cloth to remove surface dirt and smudges from the projection lens.

!Caution

Always unplug the projector when cleaning. Take care that no liquids get inside the projector. There are high voltage parts inside the cabinet that may cause electric shock.

ENGLISH

Figure 6-3. High Performance Cleaning Cloth

 3M IPC 2000 3M Multimedia Projector MP8760 19