3M MP8760 Changing Of The IR-Remote-Control Address, Changing of the IR-Remote-Control address

Page 32

A-3. Changing Of The IR-Remote-Control Address

Changing of the IR-Remote-Control address:

You can choose one out of four different IR-RC addresses for the projector, so you can control four projectors separately without any interferencies to another projector.

To change an address from the standard address #1, go to the Advanced Setup menu and choose an address of your choice under the menu item RC Address (1...4). Confirm your selection with the Enter button.

After this point you can't control the projector with the IR-RC transmitter anymore until you change the transmitter address to the same address. (Of course, you still can enter the menu system and change back the address with the Control Panel of the projector!)

To change the address of the IR-RC transmitter, please press the Mode button and an address number (buttons 1,2,3 or 4) simultaneously for 4 seconds on the IR-RC transmitter.

After this you should be able to control the projector by IR-RC again if you've choosen the same address for the projector and the IR-RC transmitter.

A-4. Resetting The Projector To Factory Default Settings

The factory default settings of the projector can be restored by pressing Enter and Mute simultaneously on the control panel when switching on the main power switch of the projector and pressing the Standby button afterwards.

The projector will start immediately and the message “Parameter factory settings restored” displayed in the starting screen will indicate the default settings are reset.

If you've had selected another menu language as english, which is the default language, you'll have to select your menu language again.

ENGLISH

 3M IPC 2000

3MMultimedia Projector MP8760

27

Image 32
Contents MP8760 Multimedia Projector Operator’s Guide MP8760 Multimedia Projector Table of Contents Safeguards Intended USEProduct Safety Labels Warranty Exclusion to WarrantyContents of Shipping Box UnpackKeep Your Packing Materials What’s Next?Parts Identification List Machine CharacteristicsProduction Description Set Up/Connections Terminal Connection PanelOperator Touch Panel Keypad 3 4 6 8 9Mouse Connection Cable ConnectionsAudio cable optional Cable ConnectionMAC cable optional Maximum f=25mm Minimum f=45mm Image Size Projector-to-Screen DistanceImage Height Power Up Projector Operating InstructionsUsing System Menus Standby ModeProjector Power Down Picture PC/RGB Description / Action Default Menu Adjustments/SettingsMain Menu Description / Action Default Setting Audio Description / Action Default Submenu Items Setting Tools Description / Action Default Submenu Items SettingAdvanced Setup Description / Action Default Advanced Setup Description / Action Default Video SettingColor Manager Description / Action Default Submenu Items SettingTest Description / Action Default Info display only Description / ActionRemote Control Remote Control FunctionsOptimize Adjust brightness Contrast for best picture Menu window positionMeaning Of The Icons Optimize Looking for signal sourceQuestion mark Battery Replacement Replacing BatteriesRemove the back panel MaintenanceReplacing The Air Filter Unscrew two retaining screws 3 securing the lamp cartridge Replacing Projection LampMay cause electric shock Can cause burns to your fingers Lamp Life Indicator Cleaning the ProjectorTroubleshooting Troubleshooting Problems and SolutionsWrong Contrast Wrong BrightnessService Information Product Specifications Technical SpecificationsPart Description Part Number Accessory & Spare Parts ListHow to Order Optional Lenses Charts Appendix=20 mm Distance D =88 mm Distance DPower Cord Sets Changing of the IR-Remote-Control address Resetting The Projector To Factory Default SettingsChanging Of The IR-Remote-Control Address Supported Data Modes and Resolutions English Important Notice