3M MP8660 manual Power Connection, Computer RGB Input Connection, MAC Adapter Switch Settings

ENGLISH

Power Connection

!Caution

To prevent damage to equipment, all power to the MP8660 and input sources must be turned OFF during cable hook up.

The power cord (Figure 3-3) is detachable from the projector and has different connection plugs on each end. Plug the female end into the power cord terminal on the projector and the male end into a properly grounded electrical outlet.

Figure 3-3. Connecting the Power Cord

Computer (RGB) Input Connection

There are two input jacks available for connecting either desktop or laptop computers. Find the cable that fits your computer type. The VGA cable (Figure 3-4) fits IBM￿ PC and compatible VGA video systems, and the MAC Adaptor (Figure 3-5) fits on the end of the VGA cable and adapts it to fit Apple￿Macintosh computers and Apple￿ Powerbook laptop computers.

Figure 3-4. IBM Compatible Computer Figure 3-5. Apple Macintosh Computer

MAC Adapter Switch Settings

The MAC Adaptor has six switches which must be set for the resolution output of the monitor. Set all switches to OFF position, then set switches to ON according to the table below:

Resolution

640 x 480 (67 Hz)

640 x 480 (60 Hz)

800 x 600

832 x 624

1024 x 768

17 inch Multiscan

Switch ON

1, 2

3, 4

2, 4

2, 3

1, 2, 5

ON

OFF

Figure 3-6. MAC Adaptor Switches

Monitor Loop-Through For IBM Compatible Computers

This connection applies to RGB output only. Video input signals are not compatible with the monitor output connection.

aPower down the computer

bConnect the monitor cable to the RGB output port on the projector.

cTurn the power on.

dSelect the appropriate RGB input mode on the projector.

6	￿	Multimedia Projector MP8660	E 3M 1997
	3M