![](/images/new-backgrounds/1191296/19129617x1.webp)
Section 3: Basic Operations
3.1 Projector Startup
O I
AC | IN |
STANDBY/ON
INPUT
MUTE
MENU
RESET
LAMP
TEMP
|
| 1 |
|
|
1AUDIO IN |
|
| RGB | IN |
AUDIO | CONTROL |
| S- | |
2 |
|
|
| 2 |
| OUT |
|
| VIDEO IN |
|
|
|
|
RGB | OUT | VIDEO |
|
|
AUDIO IN (L) MONO
(R)
Figure 3.1 Projector Controls
ENGLISH
1.Make all cable connections and line hookups with the power off.
2. Turn the POWER SWITCH | O I | of the projector on. The ON indicator will light up orange. |
3.Press the STANDBY/ON button . The ON indicator blinks (green) and then lights (green). The ON indicator will blink green during
4.Adjust the screen size by rotating the ZOOM CONTROL.
5.Adjust the focus by rotating the projection lens.
6.Turn on all connected equipment. The method of connecting various equipment, see section 2.3.
7.Press the INPUT button on the projector or the INPUT SELECT (VIDEO or RGB) button on the remote to select the source of the signal to be projected on the screen. The selected signal input is displayed at the bottom right of the screen. The display will show the last selected input source before power was turned off.
3.2 Projector Shutdown
1.Hold the STANDBY/ON button for
2. Turn the MAIN POWER SWITCH | O I | of the projector off. |
Caution
Do not turn off the POWER SWITCH before pressing the STANDBY/ON button. After the STANDBY/ON button is pressed, the fan rotates for about 1 minute to cool the projector.
3.Disconnect cables.
© 3M 1999 | 3M™ Multimedia Projector MP8725 | 7 |