LG Electronics 1024X768 XGA, RD-JT30, 800X600 SVGA manual Shutdown

Page 23

Shutdown

1.Press POWER and a warning message will appear. To turn off the projector, press POWER again.

POWER	SOURCE
AUTO	BLANK

POWER

SOURCEMENU

2.To cool down the projector, the fan will continue to run for approximately 90 seconds, during which the LED will flash.

*After the projector is turned off, there is a 90-second cooling period before the projector can be re-started.

3.Disconnect the power cord from the wall socket.

(110V)(220V)

Caution

•Please do not unplug the power cord before POWER is shut down or during the two-minute cooling process.

•If the projector is not properly shut down, to protect the lamp, the sys- tem will detect this and cool the lamp for 90 seconds automatically before turning on again.

DLP Personal Projector

Image 23

Contents DLP Projector Copyright Table of Contents Projector Specifications Timing Chart Introduction Safety InstructionsEEC Statement FCC StatementShipping Contents Projector Projector DescriptionBlank PowerExternal Control Panel SourceProjector Features AdjusterMenu Remote Control DescriptionPower Source Enter BlankResize StillZoom Mouse DragInstalling or Replacing Batteries AA type Display Size InstallationHdtv description Connecting to Various EquipmentConnecting to Various Equipment Start Up OperationDigital Keystone Correction Auto AdjustmentYP BP R Source SelectionMenu System Video Position Special TrackingVideo Menu Keystone Zoom Position MenuHorizontal VerticalSpecial Menu Clock Tracking MenuAuto Tracking Shutdown Lamp Information MaintenanceUse and Replacement of the Lamp Lamp ReplacementLED Operative InformationState LEDs Display Description Operation Status LED Status Messages TroubleshootingCommon Problems & Solutions Electrical SpecificationsProjector Specifications Technical SpecificationsRemark Timing ChartResolution Sync kHz Sync Hz Dimensions