Onkyo TX-NR579 instruction manual Error Messages, Changing the Speaker Setup Manually

Page 31

Error Messages

While Audyssey 2EQ® Room Correction and Speaker Setup is in progress, one of the error messages below may appear.

2EQ: Auto Setup

AUDYSSEY

Ambient noise is too high. Error message

Retry

Cancel

The options are:

`Retry:

Try again.

`Cancel:

Cancel Audyssey 2EQ Room Correction and Speaker Setup.

• Ambient noise is too high.

The background noise is too loud. Remove the source of the noise and try again.

• Speaker Matching Error!

The number of speakers detected was different from that of the first measurement. Check the speaker connection.

• Writing Error!

This message appears if saving fails. Try saving again. If this message appears after 2 or 3 attempts, contact your Onkyo dealer.

• Speaker Detect Error

This message appears if a speaker is not detected. “No” means that no speaker was detected.

Tip

See “Speaker Configuration” for appropriate settings (page 12).

Changing the Speaker Setup Manually

You can manually make changes to the settings found during Audyssey 2EQ Room Correction and Speaker Setup.

See also:

“Speaker Configuration” (page 43)

“Speaker Distance” (page 44)

“Level Calibration” (page 44)

Using a Powered Subwoofer

If you’re using a powered subwoofer and it outputs very low-frequency sound at a low volume level, it may not be detected by Audyssey 2EQ Room Correction and Speaker Setup.

If the “Subwoofer” appears on the “Review Speaker Configuration” screen as “No”, increase the subwoofer’s volume to the half-way point, set it to its highest crossover frequency, and then try running Audyssey 2EQ Room Correction and Speaker Setup again. Note that if the volume is set too high and the sound distorts, detection issues may occur, so use an appropriate volume level. If the subwoofer has a low-pass filter switch, set it to Off or Direct. Refer to your subwoofer’s instruction manual for details.

En

31

Image 31
Contents TX-NR579 Away from the rear panel or wall, creating a flue-like Local regulations when disposing of batteries10 cm 4 at the rear. The rear edge of the shelf or Board above the apparatus shall be set 10 cmBatteries and Heat Exposure Warning PrecautionsPower Preventing Hearing Loss CautionAiming the remote controller Supplied AccessoriesMake sure you have the following accessories Installing the batteriesContents Processing FeaturesServices available may vary depending on the region AmplifierFront Panel Front & Rear PanelsFor detailed information, see the pages in parentheses DisplayRear Panel Power cordUREMOTE Control jack See Connecting the AV Receiver for connection pages 11 toControlling the AV Receiver Remote ControllerScrew-type speaker terminals Connecting the AV ReceiverConnecting Your Speakers Connecting the Speaker CablesSpeaker Connection Precautions Speaker ConfigurationAttaching the Speaker Cable Labels Bi-amping the Front Speakers Using a Powered SubwooferHdmi cable Connecting AV componentsAbout AV Connections AV Cables and JacksAudio Return Channel ARC function Connecting Components with HdmiJack Components Assignable Jack/Port Components Assignable Connecting Your ComponentsHow to record a video source Remote Control Connecting Onkyo uComponentsConnecting a Recording Component System On/Auto Power OnAssembling the AM loop antenna Connecting the AntennasConnecting the Power Cord Plug the power cord into an AC wall outletAV receiver comes on, the display lights Turning On/Off the AV ReceiverTurning On Turning OffPlaying the Connected Component Controlling Contents of USB or Network DevicesSelecting the Language for the Onscreen Setup Menus PlaybackPlaying an iPod/iPhone via USB Understanding Icons on the DisplayEnter Listening to Internet Radio Playing a USB DeviceRegistering My Favorites*1 Listening to Other Internet RadioTop menu of Internet Radio Remote Playback Windows Media Player 11 SetupWindows Media Player 12 Setup Playing Music Files on a ServerListening to AM/FM Radio Using Remote PlaybackUsing the Tuner Tuning into Radio StationsUsing RDS Presetting AM/FM StationsMode Finding Stations by Type PTY Displaying Radio Text RTListening to Traffic News TP Using the Automatic Speaker Setup Using Basic FunctionsMeasurement procedure Use q/wto select a target, and use e/rto change the setting When you’ve finished making the settings, pressWhen prompted, repeat step ` CancelChanging the Speaker Setup Manually Error MessagesSelecting Listening Modes Using the Listening ModesInput Source Following audio formats are supported by the listening modeAbout Listening Modes Explanatory NotesListening Modes Onkyo-Original DSP Listening ModesHeight Resolution AudioDolby Pro Logic Dolby Pro Logic IIzUse this mode with any stereo movie e.g., TV, DVD, VHS Listening Mode Description Input Speaker Source Layout Neo6That fully envelops the listener Using the Sleep Timer Using the Home MenuSetting the Display Brightness VCR/DVR Displaying Source InformationChanging the Input Display Muting the AV ReceiverRecording Using HeadphonesAV Recording On-screen Setup Menus Common Procedures in Setup Menu Advanced SetupExplanatory Notes Hdmi Input ResolutionInput/Output Assign Monitor OutDigital Audio Input Speaker SetupInput selector Default assignment Component Video InputSpeaker Settings Unit Speaker DistanceLevel Calibration Double BassMultiplex/Mono Audio AdjustDolby Theater-Dimensional Source SetupAudyssey Reference Level Dynamic VolumeSync IntelliVolumeName Edit Picture Adjust Audio Selector Charge ModeDTS/DTS-ES/DTS-HD Listening Mode PresetVolume Setup MiscellaneousTuner Hardware SetupOSD Setup Remote IDAuto Standby Network Firmware UpdateDhcp Lock Setup Remote Controller SetupUsing the Audio Settings Music Optimizer Late NightCinemaFILTER Making Zone 2 Connections Connecting Your Zone 2 Speakers Directly to the AV receiverConnecting the Zone Speakers to an Additional Amplifier ZoneMuting Zone Adjusting the Volume for ZoneOperating on the remote controller Controlling Zone 2 ComponentsIPod/iPhone Playback via Onkyo Dock Using the Onkyo DockUP-A1 Dock RI Dock Controlling Your iPod/iPhoneAvailable buttons Controlling Other Components Preprogrammed Remote Control CodesLooking up for Remote Control Code Entering Remote Control CodesControlling Other Components Remote Control Codes for Onkyo Components Connected via uResetting Remote Mode Buttons Resetting the Remote ControllerSearch SetupButtons Input TV VOL q / w GuidePower TroubleshootingAudio About DTS signals There’s no sound with a certain signal formatCan’t select the Pure Audio listening mode Speaker volume cannot be set as requiredVideo Remote ControllerTuner Music Server and Internet Radio UP-A1 Dock for iPod/iPhoneRecording ZoneOthers USB Device PlaybackComponent Video OUT Important Note Regarding Video PlaybackConnecting to the Network Network/USB FeaturesNetwork Requirements Remote playback Server RequirementsUSB Device Requirements Server playbackAbout Dlna Supported Audio File FormatsBefore you start Firmware UpdateUpdate procedure Updating the Firmware via NetworkUpdating the Firmware via USB TroubleshootingErrors during an update via network Error Code DescriptionErrors during an update via USB Signal Selection Connection Tips and Video Signal PathVideo Connection Formats OUT Audio Connection FormatsSupported Audio Formats About HdmiAbout Copyright Protection About p-compatible components Using an RIHD-compatible TV, Player, or RecorderOperations that can be performed with Connection Operate with the remote controller How to connect and setupConfirm the connecting and setting Confirm the settingsVideo Section SpecificationsAmplifier Section General1080p 1080i 720p 480p/576p 480i/576i Component Composite Video Resolution ChartAvailable resolutions 3840 ⋅ 2160 24/25/30 Hz OutputOnkyo Europe Electronics GmbH UK Branch Onkyo Europe Electronics GmbH

TX-NR579 specifications

The Onkyo TX-NR579 is a versatile and powerful AV receiver that caters to both home theater enthusiasts and casual listeners alike. This model distills advanced audio technologies while maintaining user-friendly features that enhance the overall entertainment experience.

One of the standout features of the TX-NR579 is its support for 7.2-channel output, allowing users to connect various speakers to create a rich, immersive surround sound setup. With a robust power output of 100 watts per channel, this receiver can drive a range of speakers with ease, ensuring clear and dynamic sound reproduction across a variety of media types.

The TX-NR579 incorporates advanced audio technologies such as Dolby TrueHD and DTS-HD Master Audio, ensuring that users experience studio-grade sound quality for their movies and music. In addition, the receiver supports a variety of audio formats, allowing for seamless playback of different media sources.

Another notable feature is the inclusion of 4K Ultra HD video pass-through with HDR support. This enables users to enjoy stunning picture quality and vibrant colors when paired with compatible devices. With multiple HDMI inputs, the TX-NR579 accommodates various sources such as Blu-ray players, gaming consoles, and streaming devices, making it a central hub for home entertainment.

The receiver is equipped with Onkyo's AccuEQ room acoustics calibration system, which analyzes the sound environment and optimizes audio playback for the specific room. This ensures that users get the best possible sound experience tailored to their listening space.

For connectivity, the TX-NR579 offers built-in Wi-Fi and Bluetooth capabilities, allowing for easy streaming from smartphones, tablets, and other devices. Users can take advantage of popular services like Spotify and Pandora directly through the receiver, adding a convenient way to access music.

With its intuitive user interface and remote control compatibility, the TX-NR579 is designed for easy navigation and operation. Whether setting up a movie night or enjoying a music session, this receiver stands as a versatile solution for elevating home entertainment.

In summary, the Onkyo TX-NR579 combines powerful audio performance with advanced features, making it an ideal choice for both serious audiophiles and those looking to enhance their home cinema experience. Its exceptional sound quality, 4K support, and user-friendly design position it as a reliable addition to any home theater setup.