Installation and Composition

Installing and Composition

Installation Instructions

* Don’t place the projector in the following conditions. It may cause malfunction or product damage.

Provide proper ventilation for this projector.

●The projector is equipped with ventilation holes(intake) on the bottom and ventilation holes(exhaust) on the front. do not block or place anything near these holes, or internal heat build-up may occur, causing picture degradation or damage to the projector.

●Do not place the projector on a carpet, rug or other similar surface. It may prevent a adequate ventilation of the projector bottom. This product should be mounted to a wall or ceiling only.

●Never push projector or spill liquid of any kind into the projector.

●Leave an adequate distance(30cm/12 inches or more) around the projector.

Place this projector in adequate temperature and humidity conditions.

●Install this projector only in a location where adequate temperature and humidity is available. (refer p.27)

Don’t place the projector where it can be covered with dust.

●This may cause overheating of the projector.

Do not obstruct the slots and openings of the projector. This may cause overheating and create a fire hazard.

The projector is manufactured using high-precision technology. You may, however, see tiny black points and/or bright points (red, blue, or green) that continuously appear on the projector Screen. This is a nor- mal result of the manufacturing process and does not indicate a malfunction.

This product should be used adequate length bolt(within 5mm) when installing it.

When applying a ceiling installer, use only the fixing bolt and ceiling installer for pro- jector. Contact your dealer for purchase or installation.

TP-ML2

TP-MH2

To display DTV programs, it is necessary to connect a DTV receiver (Set-top Box) and connect it to the projector.

If there is no input signal, the Menu will not be displayed on screen.